Wireless

Hi guys, we have added different sites under locations in PRIME 3.0 However even after adding sites , some devices are reflected as unassigned and also reflected under that particular site. can any one having idea why they are reflecting as unassigne...

There is an option to deploy configuration in controller via Prime, however we cannot deploy configuration in bulk.   There are two options to deploy configuration in controller via Prime:  1.Overwrite startup configuration and reboot 2.Merge with cu...

Dears, I have switch down in my network and when i need to take the configuration from configuration archive tab i found all devices can access it but i can't access the down switch it was dimmed and can't open it to get the configuration archived be...

Hi, I'm doing tests with a WLC 4404 and two APs 1142 to know how this controller manage the wifi user mobility but I see that when I change of AP my smartphone lost the Internet conection during several second. The smartphone doesn't lost the wifi si...

hello, I have two controllers on Cisco WLC 5508 HA version 7.5. I'm having several sync error logs: *haSSOServiceTask3: Jan 22 09:22:51.637: #APF_HA-3-SYNC_RETRANSMIT_FAIL: apf_ha.c:2939 Maximum retransmission exceeded for client (00:0b:6b:b3:d4:6b )...

Hi, I installed the app on my mobile phone (oneplus 2),It worked fine. Somehow, now i can't see my phone under "local Connection"... The WLC  is at version 8.2.100. I didn't change anything. I checked that my mobile is connected to that WLC. does som...

Hi, In what situation  client is downshifting the rate  after a retry happened in higher rate  and even  in lower data rate  its retrying  ?. Is it  ok  an ipad mini using 24Mbps , Does it can go an higher data rate ?  Thanks

Hi I just mounted a new 551 AP on my 520 controller, and the AP powers up and have LAN activity, but the WLAN is not lighting up and I can not see the new AP in the web management screen on the 520. Might be an easy one, but my first try on setting u...

Hi, What is the difference between  ofdm rate  vs mcs rate ? Thanks

In the site settings in CMX for a site, is the Signal Strength Threshold settings measured from an access point?  I have retail stores, some inside malls and others located in strip malls. I'm trying to adjust the rssi so that CMX truly counts a visi...

Hello all, I would like to know if the Visitor Policy feature is available con Cisco CMX 10.x, or when it would be available? I extracted this from the Cisco CVD CMX design guide, which is based on CMX 8.0: "The Visitor Policy section of CMX Connect ...

We've been struggling with this problem for weeks without a solution yet. Maybe someone can help us.Note: some information below has been redacted and the IP addresses are not the original ones. They have been changed to fictional IP addresses but th...

Hi, Appreciate your support in this, Can you advise us in the following,Ap 1252 that has its three LEDs are red and has any response while connecting it via console. Thank you in advance

I used Aironet1700 [AIR-CAP1702I-Q-K9]. I changed [Autonomous Mode] by <capwap ap autonomous> command. But I want to return [Lightweight Mode]. Please tell me how can I do.

how can i disable 1552E mesh over cli. i m trying to upload ios and it s always cutting the connection. Sep  1 10:17:48.167: %MESH-3-TIMER_EXPIRED: Mesh Lwapp join timer expiredSep  1 10:17:48.167: %MESH-3-TIMER_EXPIRED: Mesh Lwapp join failed expire...