Wireless

difference between  AIR-AP3802I-D-K9C & AIR-AP3802I-D-K9  ? Its showing that AIR-AP3802I-D-K9C is configurable . what is configurable ?

Hello Folks. I'm studying for my IUWVN and I'm on Multicast topic, I spent a lot of time trying to understand the difference between MGID L2 and MGID L3. I know that when I have not enable IGMP snooping on the WLC, multicast packet travel from the cl...

We have 6 WAP371 setup on static network as Single Point Setup and every so often they loose connection.  Looking at the log file from one of the AP's I noticed that they keep changing which AP is the Dominant AP.  I was hoping that someone might hav...

Hello, recently (since around 10 days or so) one of our 1142N access points has started intermittently resetting its 802.11b interface.The log messages on the WLC always look either like this: 06:04:15 2016 AP's Interface:0(802.11b) Operation State U...

Hello Guys, Can any one help please ? till now our WLCs authentication were based on local accounts. We would like to do the authentication trough the our tacacs server( IP 10.23.49.76) I been reading about, and here is why i've got : - config tacacs...

Hi, everyone My other WLC controller died and since I had an AIR-WLC2112-K9 handy, I decided to move at least 12 access points to it. Bit unfortunately, the Operational Status of all access points is DOWN and I can't figure out why. Access point are ...

Elevator coverage for WIFI ,Has anyone successfully installed WIFI in Elevator shaft for voice ? If so how or where were AP placed

Team, Do we have any alternate option to Prime the Aironet Universal APs apart from the cisco air provisioning software ? I'd never succeed in make it to work with the Android Cisco Air provision. I've been struggling for weeks. Also, I have not inte...

On our WLAN there is an option to select which radio we want to use.  We can use all of them or these a only, a/g only, g only, and b/g only.  We just set the wireless up and had a only selected, but found out today we have an older laptop in house t...

Dear Sir,           We have a trouble in configuration when we make HA for WLC 2504. Could you please to guide me how to configure WLC 2504 and this device can support HA.

 Hi, Can anyone throw some light on what the Back-up Primary Controller and Back-up Secondary Controller values entered within the Global Configuration menu under Wireless --> Access Points tab on the GUI screen of Cisco 5508 WLC.Requirement: We have...

i bought Cisco AP 1832I and it is not broadcasting ssid. i think it has lightweight AP firmware so i need help to update that. how would i connect or setup this Access point? i don't have wireless controller. i have connected AP to D-link PoE switch....

Hi, I have a cisco 7937g conference phone and it all works fine apart from when I am trying to connect to a webex. It wont recognise anything I enter via the keypad, e.g. pin code or conference id. It works fine with everything else. Any suggestions ...