Wireless

Hi all,I have a Virtual WLC (software image version 8.1.102.0) with AP 1600 and a NPS service already installed with windows 2012 R2.I think, I have a problem with the MTU Size.The authentification doesn't match and if I look my Ethernet Frames, i ha...

in  switch, I have one interface G1/0/35, type: trunk, connected to access point 2, in switch G1/0/35, can we list out the IP address of AP 2? how would I know the IP adress of AP under my switch under g1/0/35, currently, there are three mac address ...

Hi,I have a stack consisting of 2 WS-C3650-24PS (version 03.03 .05SE) configured as MC and 4 AIR-CAP3702I-E-K9.Everything is working properly and the APs are joined without problems, but only if the port of the 3650 is configured in access mode. This...

Hi,I have purchased new Access point 3700 series (air-cap3702i-e-k9), please kindly guide me to configure. I have try to get global config mode but I can't get it. bestChandra

Hi All, I have a client replacing their existing WiFi with a Cisco solution. They currently have a guest SSID with a PSK and have an external proxy presenting an AUP disclaimer page that they have to accept before proceeding - they initially want to ...

Hello ! I'm looking for advice in this matter. We have one virtual WLC with base-ap-count license for 40 APs (we bought L-LIC-CTVM-UPG and 7 x L-LIC-CTVM-5A), but we are using only 18 APs.We are going to buy another one WLC for remote office and want...

I'm in a situation where I would like to plug another standalone AP into the AUX port on another standalone 2702.  No controller is used.  I'm wondering if this can be done, or if it will work.  I can will have power adapters for both.  I'm going to ...

Can someone give me concrete reasons why we should NOT enable broadcast forwarding to resolve the issues as described below? We have roughly 85 - 2504 WLCs all running 8.0.120 code scattered across 85 physical sites.   We have an issue that I have fi...

Hi there we just upgraded our Cisco WLC 5760 from IOS XE 03.03.03 to IOS XE 03.06.03 and every thing seems to be working fine, except that we get a lot of the following error messages:Sep 24 13:00:10: [CAPWAP] %Error: fast_ipwrite returned 2. Try ipw...

Hi, trying to get an AP to register with the controller, but it aint happening. I was reading an old post:https://supportforums.cisco.com/discussion/12503981/cisco-air-ap3702i-uxk9-flashing-redgreenoff-registered-wlcand it mentions that the AP is un-...

Need a in between solution for APs..need to find out the CISCO AP model that support standalone mode (autonomous mode) for now. AND these AP will convert to lightweight (with WLC) at later time.The current new 3700, 2700 and 1700 seems all use WLC.. ...

hello everyone, we have a problem with the ip mapping on connection of ISE and WLC. this is how is our network:vWLC: 8.1.111.0  IP:172.16.100.14          ; virtual Ise: 1.0.3.876    IP:172.16.100.17Both are on the same virtualization server.The users...