Wireless

I have 3 5508 controllers on 7.0 software which supports older aps i.e. 1231 ... For new expansion we have purchased 3602's which only run on 7.2 or higher. I have a 4th controller that is on 7.4 ... can I connect the new 3600's just to that controll...

what is the exact procedure when restarting two CPI appliances configured in HA?should the HA be removed first?should the second appliance be 'ncs stop'ped first, followed by the primary ? 

I have two WAP4410N access points set up for B/G/N intermittently I will not be able to connect with iPhones or iPads. It seems I have to reboot all devices all the way back to router to fix. Sometimes that does not even work and I have to repeat sev...

Hi All, As we know, an AP stores its last known WLC's in its NVRAM.  Is there anyway to remove controllers from that list? i know there is a CLI command to specify a controller - capwap ap controller ip address x.x.x.x - so i am hoping there is an al...

hi all,my bar code reader motorola MC9190 can't connect to wifi net with wpa/wpa2-tkip psk. i receive the following error: TKIP MIC errors reported in EAPOL key msg from client 40:83:de:89:0a:33 WPA_KEY_MIC_ERR: 1x_eapkey.c:618 TKIP MIC errors report...

I just installed a 2504 WLC (7.6.130) for a customer of mine.  This is used just for guest wireless and has it's own dedicated internet connection. When testing bandwidth for the customer we see the full bandwidth when wired into the router 100MB.  W...

Hi,I need to buy vWLC license for 200 AP but only part number I can see is L-LIC-CTVM-25A which is 25 AP license.Do I need to buy 8 of these?What if I need to support around 300 AP then Do I need two vWLC controllers ?. can I run them in cluster so t...

Hi All,Currently i have 2 5508 WLC, 1 in Enterprise Network and 1 in DMZ as Anchor Controller behind Meraki Firewall, we are running  mobility new-architecture (CAPWAP Tunnel) between both the controllers to form mobility group, I have been said that...

Hi guys, I'm attempting to setup 802.X at a client site and are having issues and can't make sense of the logs. I have a created a test SSID with the modifed L2 Security settings (WPA2-->AES--802.1X). I have access to the WLC but because the client i...

What is the best way to implement wlan printing with a wireless printer? Enabling wireless clients to print on this wireless printing.

Hello Experts,I have configured couple of sites with Flexconnect AP. all the sites are working fine and no issues.But I see a strange issue for a new site where I see E.g. I have configured ssid = abc, on the site I see is displayed SSID = (wireless ...