Wireless

Hi all, I am having trouble getting a 1532E outdoor accesspoint to show up in prime infrastructure. The AP joins the controller, but won't show up in prime.It is a lightweight accesspoint.Prime version is 2.2Controller IOS is 7.6.130.0 Does anyone kn...

Hi,I have strange issue with some 1532 APs. Periodically (approximately after one week) the 802.11a radio interface goes to operational state down.This happens by no obvious reason.It comes back up after an Admin status enable/disable, but I would li...

i have a problem with a 2602e access point that he wouldn't join the controller (wlc 8510)i gave him the image --> p3g2-k9w8-tar.152-2.JB.tarwe have a lot of capwap ap's but ive never had this problem before*Jul 19 07:53:59.999: %DTLS-5-SEND_ALERT: S...

Hello,I have a 4402 WLC running version 7.0.251.2 and a WCS running version 7.0.164.0.I was hoping to upgrade the WCS to version 7.0.240.0 but wasnt sure if it was compatible, the only document I can find is attached below, it says though '2500 serie...

In Cisco download page we can find AP IOS images (w7) and LAP images (w8) so we assume there is a possibility to downgrade one 1520 in LAP mode to Autonomous with the traditional procedure (renaming IOS to default).But I have seen a comment in a post...

Hello everyone,       Hoping someone can assist me, I am trying to locate where to download the cisco aironet desktop utility version 4.5.  I found some technical documentation here. http://www.cisco.com/c/en/us/td/docs/wireless/wlan_adapter/cb21ag/a...

Hi All, Can someone please advise. 1)Where to check if the WCS has taken backup of WLC?2)The directory it will store configs in? Thanks

Good Morning/Afternoon!  I recently configured a 55XX series WLC for Application Visibility in advance of student testing in a local Alabama school system.  Internet access for student testing will be provided via the campus Cisco wireless LAN and Ch...

So this question may seem extremely simple however I'm having no success following the methods I have found so far.I received the LAP1142n used with a configuration already setup on it. My end game is converting this device to an AP because I don't h...

Customer is thinking of using Terrawave antennas with some AIR-CAP3602E-A access points.I am wondering what the support impact is going to be with using non-Cisco Antennas for warrenty or support.Is there a compatability document somewhere or is it u...

I can not insert a mac filtering with admin account ,and wlc appear message “authorization Failed. no sufficient privileges”. but sometimes i can insert a mac into mac filtering.anyone knows what's going wrong? and how can i fix that. thanks

Can I use an 2702 AP with AIR-ANT2506 and AIR-ANT5160V-R anntenas?

Hi all, we run several 5508 in HA mode. Is there a possibility to detect a HA failover through syslog or snmp? I was not able to find any information on the web about syslog messages or snmp OID's regarding cisco's HA failover. The problem we face is...

Hello EveryoneI have a problem, last weekend I performed HA in 5508, using a spare of WLC, in secondary I installed a new license for supporting 50 APs, Main WLC supports 25 APs, however when I enabled SSO in secondary, this one went to Maintenance M...