Wireless

Hi all,I understand that it is possible to have the WLC send different NAS-ID attributes to the CIsco ISE so that I can create specific AuthZ policies based on that NAS-ID attribute.The only thing is that I cannot see anywhere in the FlexConnect AP G...

We have two Wism2 controllers running 7.3.10 and in the last 30 days they have both doubled the memory usage on the controllers. They went from 26% usage to 51% usage. Is there a way to figure out what may have caused this increase in memory usage an...

I have configured WLC NTP, time and timezone, however the Acess Point time got a 5 five hour difference, how I syncronize WLC time with AP time?thanks.

Recently a customer plan to migrate their old WCS to PI2.1. The issue is they are not upgrading the WCS VM. Instead they bought a new NCS appliance for PI2.1Has anyone tried to migrate the data from WCS to PI2.1 without migration process to NCS1.1.1....

Hello Allfor 802.1x authentication what should be the security policy confgiured on the WLC [WPA2][Auth(PSK)]or[WPA2][Auth(802.1X)]or?? hope to get some helpVR

Hi everybody: Some months ago , i had to upgrade our WLCs to the version 7.4.110, but the WCS doesn´t support these WLC ios version, then i decide to migrate to the NCS, i found some docs that explain that NCS v .20 supports these IOS WLC version, my...

In PI, there is Unique Clients Summary, what kinds of unique clients this report related to? associated clients, authenticated clients or other kind of clients? 

Dear Team, I have Cisco 5508 wlc along with WCS. Kindly advise if I can install wIPS in my wireless network. Do I need to purchsase the MSE is mandatory for this wIPS installation. Regards,Jubair.S

Hi,OK, he is a intreasting one. I have a ASA 5510 which has been running fine (and still is). Not had any problems with devices etc. connecting to outside work and back.I'm trying to get a Meraki AP working to trial, however I'm getting something ver...

I have 4 red LEDs in the AP. how to upload the image to the AP.

 I have 2 WLC's running in SSO mode, and I need to replace the Primary Box.I have the Redundancy Ports directly connected with a Ethernet CableI made a backup of the Primary WLC.And enabled SSO, with the same IP Addresses I have used on the PrimaryAs...

Hi all,I have a problem with a AP template on Prime 2.0.I have a WLC pair (7.4.121.0) setup as N+1.Now on the Prime (2.0) I created a Lightweight AP Configuration Template, setting the Primary and Secondary Controller name (from Dropdown) and pasted ...

I am getting ready to install some 3700 series AP's and then also configure the WLAN controller to support 802.11ac.  I was reading on the net that there are basically 5 80Mhz channels you can use however when I look over Cisco documentation I do not...