Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Welcome to the Cisco Community Ask Me Anything Event   Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...

Shree Hari AB.jpeg Screenshot 2026-09-11 at 3.12.04 PM.png

Hi guys, We've just purchased 4 of these WAPs and are now getting them set up - first issue we've run in to is it blinks Red / Yellow / Green. They didn't come with a manual, and the documentation on this site doesn't mention the LED being capable of...

sorryboss23 by • Community Member
  • 1400 Views
  • 6 replies
  • 0 Helpful votes

Hello.I have bought a Cisco Aironet 1200 AP.I need to change it from lightweight the autonomous.Can someone please help me to download the ios as when i try to it sayes i cannot download the ios using my account.Thank you for your help.

cctvakl01 by • Community Member
  • 10059 Views
  • 5 replies
  • 0 Helpful votes

Hi All, Not sure if this has been answered before or not but has anyone been able to get reverse telnet workig with a 4402 WLC (i am using a 2511 access router).I have tried manual configuration of the line but so far no success - the session appears...

Yes

Is there a way to configure a 2600 AP without a console cable and a controller to set the IP address first?

QuikTrac1 by • Community Member
  • 703 Views
  • 1 replies
  • 0 Helpful votes

Guys,Please help me understand this. I am used to getting access points with omnidirectional antennas, however, i need an AP that can be placed on the wall (not ceiling) and send the signal in a   certain direction only. For 3700i, the signal is basi...

Hi Experts, I was trying to figure out how the AVC reports capture the effects of implementing AVC!!Do we have any reports which show the optimization or prioritization provided to certain application traffic as a result of AVC feature?    

mubhat by • Community Member
  • 1164 Views
  • 2 replies
  • 0 Helpful votes

I am using the WLC 5760 My SSID use WPA2 PSK and i don't use ISE or Radius or AAA to authentication Some client can connect to the AP,but can not ping the gateway When i show logging from WLC,it will see the log like %AUTHMGR-5-FAIL: Authorization fa...

Resolved! 5508 HA-SKU

Hi,I need to determine how the HA-SKU backup controller configuration is done, how it is different from SSO-HA. I need the procedure to implement.HA-SKU is different in that it employs two 5508's where one 5508 alone (AIR-CT5508-HA-K9) has the HA des...

lcaruso by • Level 10
  • 1071 Views
  • 2 replies
  • 0 Helpful votes

Is there a way traffic can be prioritized by ssid, so that the traffic authenticated to one ssid gets preference over another?  How can I guarantee performance for one ssid over another?  The code version on the controllers is 7.0.240.0. They are 440...

I've been trying to upgrade a couple phones to 1.4(4). Call service is CME 8.6. The phone authenticates to network (WEP), downloads config files and attempts to register to CME, at that point the wireless link is dropped, "network busy" is shown. Ano...

Review Cisco Networking for a $25 gift card