Wireless

First of all greetings to all in the community.The problem I am running is in the roaming phones mainly iphone, which I have them in a SSID also serves to data connection of other devices which has the following security policy [WPA + WPA2] [Auth (80...

Hello everyone,I would like to share with you a strange issue.     After a WLC upgrade (version 6 to 7), we noticed that the bandwidth had been reduced by twice.The only workaround we found to restore the bandwidth is a reset of the LAP to factory de...

Dear experts,I am using a WCS 7.0 application on a linux Server .Few days before we observed that the all the client reports generated are wrong . the Datas are not geting refreshed .in the Client session report the data i am getting is one mont olde...

Hi ,I need a WCS report that will actually give me the top n Wireless Access points that have too many clients trying to authenticte to them. We have some serious capacity issue in meeting rooms but we need figure of how many WAPs might be affected. ...

Can I get a sanity check? It appears that through NCS, you cannot create a template that eneables and disables an individual WLAN- only APs?

With Flavien Richard Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about 802.11 radio, MIMO, new APs, antennas and antenna placements, as well as outdoor requirements and Mesh wi...

NCS, MSE, 5508 Controllers (7.2 Code). Through NCS, in Rogue APs list, the Map Location column never shows any thing despite the MSE and locations/controllers/designs all being synchronized. Then, drill into any rogue AP, and the detecting APs do not...

Ok, so with my WLC2504 implementation, I use the 4 ports to physically segment my wireless networks. Here is my setup:Port 1 (Management) - Internal IP so I can manage the WLC from our internal network (Untagged)Port 2 - Connected to our core stack a...