Hi all,has anybody deployed AP2600/2602i over fastethernet Port ?My AP's are still in REG state, admin up but oper state down, so no radio is up.I am not sure what the problem is, but as I tried to look for any issues I read the quickstartguide again...
I have a customer that notes their Wireless is running great for laptops (Windows 7, EAP-TLS) but they note their iPads get disconnected often. Isn't this a known Apple iPad isues? Anyone familar if Apples has fixed any wireless issues in recent iP...
Hello,We have just gone live with our wireless refresh, using a Cisco 5508 (v7.5) and Cisco 3602i's with the 802.11ac module.I am having some issues trying to get the AC modules to come up. The AP's are powered by a PoE 3750 switch, which is only cap...
I have a AIR-LAP1242AG-E-K9 that I was working to flash to the Autonomas version AP1242AG and during that process I guess I held the mode button down longer than 2 seconds when I tried to factory reset it as now everytime I boot it...
Dear Sir/Ma,please kindly advice. My company wants to go into full collaboration(becoming a collaboration expert) which specilaised exams should i write? or certification path to take?how can i go about this?bradebola
Hi Everyone,We have users who are able to get the IP address but unable to access any internet sites.I check the trap logs on the WLCRADIUS server 192.168.50.1:1812 failed to respond to request (ID 16) for client 88:53:2e:99:24:b5 / user 'unknown' RA...
Hello,Lets say I have two APs in mesh one as RootAP and one as MeshAP. Backhaul interface is 802.11a. The question is, is it mandatory to have 802.11a network enabled on WLC as well for APs to see each other?Thanks.
Hi,Please understand first the reason for asking this question is I've had a case open with TAC for two weeks now without solution, so we've probably covered most of the obvious points or questions one could ask. Notwithstanding, is it possible to us...
Below is symtom when the problem happen- user not able to connect to the cisco ap but able connect rackus ap- window laptop able connect cisco ap without problem- need to wait 1 day for the macbook can reconect back to the wireless- no log error whe...
Hi Everyone,I am new to Wireless.Need to know few commands to check the health ,status and troubleshooting for WLC2100?Like CLI command to check how many AP are connected ?What users are connected to AP or WLC?how to check which ...
Will need to know if some one has deploy a Controller in a HA mode can be on a "COLO" (while the primary is on HQ) thru a MPLS cloud of 10 ms delayEven the keep alive setup says 100-400 ms is there anything on management and redundant port that I nee...
Hi,can you give me some hints how to approach and design this project.There are guidelines:- 1h of free internet access to anyone - users have to accept terms & conditions on captive portal before they're able to start browsing- after 1h session disc...
Hi,I understand it is a best practice to have the managment interface set to vlan 0 on the WLC. Why?If multiple ports are trunked to the WLC and the WLC has an address in vlan 3, does that work or how do I make that work?Right now the WLC is set to v...
Hi my name is IvanI would like to know if there are any cisco wireless product that allows user to view applications in the wireless network are used and how much bandwidth is consumed per user and per application.Thanks for your reply.Thanks.
HiDo we need to connect the Access point at the L3 switch or we can connect to L2 switch also.As i have read in the cisco site that CAPWAP tunnel will not support with L2 switch .Please suggest... which switch i need to take Thanks & RegardsLakshman ...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 10-15-2026 05:58 PM | ||
| 10-12-2026 06:46 PM | ||
| 09-30-2026 07:34 AM | ||
| 08-10-2026 11:32 AM | ||
| 08-06-2026 09:29 PM |
| User | Count |
|---|---|
| 5 | |
| 2 | |
| 1 | |
| 1 | |
| 1 |
