Wireless

                   Looking for ideas on how to deal with the following issue:We're utilizing webauth w/ passthrough for a guest SSID.  We have a cert (so no warning on client connect) and it works beautifully - unless a client is, for instance, signe...

Just about to embark on a WLC 2500 purchase for my LAN, I have a good idea on how I will configure the internal access to our corporate LAN. I was looking for some for guidance with the Guest portion. Is there any best practices or examples of how th...

I have a questionI have a wlc 5508 with license base to a capacity 100 AP. I have already registered 65 AP, and now  I need to register in to wlc 57 AP more.I would like to install a license of evaluation by 30 days. After that i'm going to purchase ...

We removed the APs on a floor while its under construction, and obviously it triggered alarms in CPI.  Correct me if I'm wrong:If I acknowledge the alarm, if an AP disconnects from the controller after I install them it will not trigger an alarm.I sh...

I am trying to setup another network on a AP that has already has a company and guest network set up. The new network will not be able to reach anything on our side. We have setup and configured a new 1921 Router to give this branch Internet access. ...

Question is will POE on a 4006 switch handle the power requirements for the latest 3602 series APs.Thanks

There is a huge amount of CAPWAP traffic from access point to the ap manager IP address of WiSM1 . Around 215 gig. Is it normal or something strangeSent from Cisco Technical Support iPhone App

Hi All,We set up a Cisco WAP for one of our clients. It is running WPA2-Personal with AES. One of the bosses at this client recently bought a MS Surface Pro and is unable to connect that to the wireless. Some research into the issue shows that this i...

Hello!We have a WiSM2 (version 7.4.110.0) with approx 200 APs. We are doing RADIUS authentication via a PacketFence backend. Everything usually works fine, but we are having an intermittent issue...The WiSM2 gets its VLAN assignment for a client from...

We have two WLC 5508 and one foreign guest anchor WLC at the primary data center, also a 5508 box. I would like to connect an AP directly to the guest anchor WLC through its guest VLAN interface, so that the same configuration is applied to it as oth...

Hey All,I've installed a second Cisco ACS server for redundancy on our WPA2/AES/802.1X wlan and I was wondering how this will affect user connections. I have 2 ACS's with 2 different certificates and they are setup as radius 1 and 2 under this specif...

Hey All:Im having an issue with some 7925G, the A / 5Ghz inside works like a dream, when we go outside the phones start going crazy, we have 1310G's outside using 2.4GHz, the phones just wont roam. If you stand 30 metres from the external AP towards ...