Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
I already installed several VoWiFi projects but all of them had the same problem: the wireless phone (7920 or 7921) decides to roam when it reaches the rssi +/- -75dBm (sometimes -80dBm), when there is a better option like -60dBm earlier, which cause...
I tried installing chained certificate in for the https access in wlc 5508. It failed and later i came to know it will only accept unchained cert for management access. But now the problem is i could not get GUI access. It shows error like "This serv...
Hello,I have a little experience with cisco routers but none with the air AP1242AG.The project i am working now is about giving wifi to a village. There is one ADSL router, one switch (2690) and several AP1242AG.Is it possible to have the following t...
I am havingissue with flexconnect mode AP. They are losing vlan mapping very frequently. I need to reconfigure the vlan mapping then only client starts getting IP addresses. Please let me know what may be the issue.AP model: AIR-CAP3602I-N-K9 WLC mo...
HiLooking for advice ....we have a corporate uk wide wireless ....it has a big subnet and on average 754 active clients at one time . Whet is the recommendation per vlan ? Is it the same as a LAN based network ( 254) .Any advice would be great thanks...
HiThanks for response my anterior question, well I have the next question.With the WLC 2504 with iOS 7.4 support 70 APs, and I wish to know if for support the 70 APs I need use the 4 ports, because I see problems with my APs,(41 APs), because exist d...
Hi All..I'm having some problems setting up a guest wireless. First of all let me explain out set up1 x ASA Firewall3 x SF 300-24P 24-Port 10/100 PoE Managed Switch's6 x AP541N-E-K9We have set up the company wireless which worked fine.However i am t...
Looking for setup controller based wireless bridge or AP to cover 300m X 300M ground area. Need to know wireless ap , antennal to support for setup.
I'm trying to use customised captive portal for C5760 controller.After uploading the customised page, the captive portal still points back to http://virtual ip/login.html.Have anyone successfully uploaded and managed to used customised captive portal...
Hi,Because of end-of-life of the wireless AP 1140 series, we decided to switch to the 1600 series.We have now several AIR-SAP-1602E devices which show the same behaviour:On the web interface, there is an error indicated for the transmitter power (see...
Hi,I have run config analyzer mostly for audit purpose and i have seen the below result after running an RF analysis (see below).I understood that above 900 the RF index could indicate an issue. Is it relevant ? If my asumption is right, where should...
The release notes specify that you must break your HA pair before upgading, but I am not aware of a recommended procedure to do that. I am also looking to find experiences from anybody who has upgraded and has any insights good or bad in relation to ...
Does prime infrastructure1.2 compatible with wlc 7.2.115.2 ? From cisco compatibility matrix I found this: but nothing about wlc 7.2.115.2 and prime infrastructure 1.2
Dear All,I am planning to buy new AP for my existing setup. we are using 1131AG series AP, we need to go for new one with n supported with external antenna.Current software version on controller is : 7.0.235.3Thanks,AS
I have ordered 2602I LAP with -S regulatory domain (singapore) while I need to opearte the LAP in india.Need to know if there might be any problem which might arise and relevant solution or rectification for the same.
