Wireless

Is there away to configure ACS 4.2 to only allow certain EAP-type of authentication per SSID? For example: SSIDA - only allows EAP-TLS and SSIDB - only allows EAP-PEAP on the same ACS server?Any help is greatly appreciated.Sent from Cisco Technical...

A 4402 Controller (Software Version - 7.0.98.0) with Web-auth via LDAP database works fine for a random time, two days, some hours.The LDAP in controller is configured with a user, that has bind's privilegies.I don't know why the authentication of us...

Hello, I have two Aironet 1310s out doors - one on a boat and the other on a building. I have one ANT24120 antennas attached to each AP. I am trying to determine why I am having dropped connections. Any help would be appreciated.

Dear All,Would like to enquire regarding 2 x WAP4410N access points that we have installed at our site.  These devices work fine with the power brick but when conmnected the SG300-28P ports POE lights up, and seems to keep rebooting for some strange ...

Hello,  I have two Aironet 1310s outdoors - one on a boat and the other on a  building. I have one ANT24120 antennas attached to each AP. I am trying  to determine why I am having dropped connections. Any help would be  appreciated.

The story is that we recently upgraded our 4404 controller to the new 7.2.0.230 code. This upgrade was from 4.2.209 code. I would like to make the change to the Multicast setup so that It is multcasted and not unicasted.So I went into the controller ...

My aironet AIR-AP1131AG-E-K9. has 2 small LED, which is E and R , This R led is blinking with red color, I want to know what does it mean.Best regards

after upgrading the firmware on the wireless lan controller 5.2.178.0 on my cisco 4402 wlc's and rebooted the devices, I am getting matches on the audit status between whats on the contoller and the wcs software. so i am trying to apply whats in the ...

Hello everybody,I did finish all the configuration steps for Cisco Aironet 1140 AP1140 mentioned in the manual and AP start showing green indication:Step 1 The static IP address of the PC on which your TFTP server software runs should be between 10.0...

Hi,I have the next problem.The interface Dot11radio0 is always in reset / down status.I can't link both AP.They both are cisco AIR-AP1252AG-E-K9.This have been working fine for 18 months, but this week suddenly went down.I updated yesterday one of th...

I have a customer requirement indoor and outdoor APs,  i have suggest to customer............   1. 1 no of AIR-CT2504-50-K9 (Controller, supported 50 LAPs)   2.  25 nos of AIR-LAP1141N-A-K9 (Indoor LAPs, with PoE injector PWRINJ4)   3.  14 nos of AIR...

Someone has mentioned only 25 nodes are supported by the 1524SB and that one AP gets bogged down by 20 nodes or more. Is this true?Sent from Cisco Technical Support iPad App