Wireless

HelloI can not find in documentation order of operations on the interface.Everybody talks just about NAT, encryption. What about other features ?For IOS it's well known, example:http://etherealmind.com/cisco-ios-order-of-operation/What about ASA ?Tha...

I have installed the 1.1 OVA but when i try to upload the 1.0 license and get an error.  Is the error dude to the fact the version is 1.1 and I'm trying to upload 1.0 licenses?thanks in advance..izzy

We have a WCS as well as a MSE.  We where using the evaluation license for a time, however it expired.  Since then we have been getting an alart in the WCS that it has expired, we have no interist in getting a licnese for the service, how do I stop t...

Hello,I have a Cisco AP1142 Standalone AP at two of my locations. However both of these are being rendered useless every night and require a reeboot to correct the issue, because of the high level of noise and vibrations coming from the extremly loud...

Hey folks,I've been assigned to look into whether we can use our Cisco ASA5505 to basically create a hotspot in one our apartments.We'd like the user to basically 'agree' to terms before getting access to the web.Can anyone tell me if this is possibl...

Hello,In the document "Cisco 2500 Series Wireless Controller Deployment Guide" http://www.cisco.com/en/US/products/ps11630/products_tech_note09186a0080b8450c.shtml Cisco states that " The Power over Ethernet (PoE) ports on the Cisco 2500 Series Wirel...

We currently have a large deployment of 1131ag APs and we are moving to 1142 APs in the future for new installs/replacements. I thought I read somewhere that it was not advisable to mix 802.11a/g and 802.11a/g/n APs in the same area because it could ...

Hello,We have had several APs disassociating from our controllers. The alerts say, Message: Access Point 'AP-xxxxx' associated to controller '10.x.x.x' on port number '0'. Reason for association 'Dot11g Mode Change. I have read several posts that poi...

Hello! I've been poking around the Reports feature of our WCS Controller (version 7.0.164.0) and I'm trying to figure out how to get a history of the number associated clients on a particular AP over a specific date range. Is this possible? Thanks!

Hello, I need some help purchasing the correct equipment for my sports facility. LAN is already setup and configured all we need to add is a wireless option with a main and guest network. We have 42,000 square feet in one large open gym. Also we need...

Hello ,I am looking for a 802.11 b/g/n Access Point that is EAL level 2 certified, which AP can I select?Thanx

I have some problem with 802.11A radio is enabled but the detaild status is still display software status is disabled and hardware status is down. I checked the settings on Enable Radio is checked on enable. I can't get any radio accross. Any ideas w...

I changed the role from Installation mode to Non-Root bridge then the Software is disable and Hardware is down in 802.11A radio. How do I enable it again without reset to factory?Thanks