Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

The client has 100 small remote offices and each office requires a wireless AP. The goal is to deploy cisco WLC 5508 at the HQ site and each site AP will connect to HQ site over the MPLS network. The client was interested toKeep the cost low for the ...

Hi,I have 10 APs (Static IP) connected to my existing Wireless LAN controller in subnet of 192.168.1.x network in VLAN 127.The WLC (ver 4.1.171) is connected to a switch in trunk mode carrying VLANs 127-128. The managemet interface is configured as 1...

I have a client who stores large volumes of video footage archives. They are concerned that there may be impact on their archives from WIFI. We are in the process of performing an onsite survey (for AP placement) and they are now requesting any infor...

borgiar by Community Member
  • 828 Views
  • 1 replies
  • 0 Helpful votes

Dear all,I'm new to this and I have question.Imagine location where are two switches, and I can't use wire to interconnet them, but I have to use wireless.Can you suggest solution?Topology:clients <-> switch <-> AP   air   AP <-> switch <-> clientsI ...

I new to Cisco, the 5508 WLC, and H-REAP...  I am setting up a 2 WLC's one at the primary data center and a second on at the backup datacenter.  I have a total of 8 sites that will be utilizing the WLC.6 of the 8 sites will utilize H-Reap back to con...

michaelkdj by Community Member
  • 1263 Views
  • 1 replies
  • 0 Helpful votes

The client has 100 small remote offices and each office requires a wireless AP. The goal is to deploy cisco WLC 5508 at the HQ site and each site AP will connect to HQ site over the MPLS network. The client was interested toKeep the cost low for the ...

Hi,We have implemented a Guest WLAN using a 4402 controller residing  in our internet facing DMZ environment.  EoIP tunnel forwards traffic  from internal controllers to DMZ anchor.  The service works well and is  very popular with third party contra...

I know what the problemis i need to tell the AP what the mac of the switchport is but i can not figure it out because it is a CATos Switchon a IOS  I would just use the Show interface command and use the bia but i dont know how to figure out the bia ...

Hello NetPros,I have two 5508, no anchor, only one SSID with internal web authentication using radius server.Under "Configuring Mobility Groups", Cisco guide says: "If a client roams in web authentication state, the client is considered as a new clie...

apasquino by Visitor
  • 5350 Views
  • 6 replies
  • 0 Helpful votes

Hello, I've two wlc model CT5508 version 7.0.116.0. They are working fine except for the RF grouping part. When I look at the RF Group members part in the configuration, I can see only one wlc (the one I'm connected to). If I connect to the second on...

theophile by Level 4
  • 2855 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card