Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I have a WGB in a mobile unit that will connect to fixed LAP along a route.I understand the LWAPP tunneling and the idea behind that.The only thing I can wrap my head around is how the routing/switching works.  How does the WLC or WiSM (we have two 6...

jfraasch by • Level 6
  • 1462 Views
  • 3 replies
  • 0 Helpful votes

Hi,I have a WLC 5500 with image 7.0.98, and I can not use bonjour services.My broadcast and multicast are enabled.Ethernet Multicast Forwarding............... EnableEthernet Broadcast Forwarding............... EnableAP Multicast/Broadcast Mode..........

jgrement. by • Frequent Visitor
  • 5062 Views
  • 14 replies
  • 0 Helpful votes

Resolved! Cisco WLC 2125 HA

HiI have a single Cisco 2125 WLC installed at my premises.I would like to know if this supports failover mode/cluster/HA etc and if it does how do we do it.Will it act as active/active or active/passive?Thanks

Quick question. I have a customer that wants to deploy ethernet into 9 buildings. The issue is we can't physically cable them together. We have looked at a Cisco 1300 bridge deployment with  1200 series AP's in each remote building, but there's is no...

awcevans01 by • Community Member
  • 1801 Views
  • 3 replies
  • 0 Helpful votes

I apologize now for the crude quality of the drawing I made.I need to provide a wireless hot spot to one area of a parking lot. Mobile clients will roll up to the hot spot and connect to the network. I want to use a 3500e AP with eternal antennae. I'...

b.gamble by • Level 4
  • 1669 Views
  • 2 replies
  • 0 Helpful votes

Resolved! Cisco AIR-AP1142

Just out of the box. Configured IP address, security and enabled the radios. When I checked the gigabit interface it shows:      Software status -- Enabled      Hardware status -- DownIs this an indication that the AP has a hardware problem and I can...

mcaoile by • Level 4
  • 1900 Views
  • 4 replies
  • 0 Helpful votes

Hi All,I'm having problems with the DHCP assignments to the guest wireless users in a site.I'm using a H-REAP setup with 3 WLCs and a number of APs that support H-REAP(1140, 1240).The remote sites are spread all over Europe.One of the WLC is used as ...

Hello,We have a 5508 wireless controler, 1141 LAP and an Ucopia on the same building.I wish to add 1141 LAP on an agency. There are no link between the two site, and the agency have a classic internet access.Have I to use a security appliance to etab...

Anyone have any experience with 1250s set up as WGBs or know if it's possible?I have a large number of 1240s currently running as WGBs, but as we are migrating to 1140/1250/3500x APs we'd like to take advantage of 802.11n on WGB side and replace the ...

roboswald by • Community Member
  • 953 Views
  • 2 replies
  • 0 Helpful votes

I am attempting to set up a WDS using 1240 series access points as the WDS APs. I believe that I have the set up correctly done, but  1240 series AP that is the infrastructure client say the the RADIUS server is dead that is on the 1240 wds-server, b...

garn321123 by • Community Member
  • 5779 Views
  • 4 replies
  • 0 Helpful votes

Hi all,     I'm running a 2106 with version 6.0.196.0.  I'm running a couple indoor 1131s on it for regular client access successfully, but my problem is with trying to Ethernet Bridge Wireless Mesh two 1522s.  I have placed the 1522 MAC addresses in...

Hello,I'm new to the community and wanted to see if I could receive a little assistance with a question I had regarding the Aironet 1300 wireless bridge.Is there a way to statically assign only one MAC address for the bridge to connect to instead of ...

Dear allI want to extract one of the license files of my WCS because I lost the original file. If you know how to do it, could you please tell me?Thank you.Yours,Antony

HiCan I use two Cisco 1522AG access points as a bridge? - just as the way two 1300 series or 1400 series APs would be used.For example one 1522 AP as a RAP and the other as a MAP whereby the MAP is connected to a LAN that is to be bridged....is this ...

Review Cisco Networking for a $25 gift card