Wireless

Hi everyone,I have a cisco aironet 1100 series wireless access point, by misteke i upgarde ios image to 1200 series. before upgarde i erase flash from 1100 AP.when i reload the AP all leds lights are solid green, tried to set factory default but no l...

Hi GuysDo you know whether Cisco are planning on designing an ISR that can also benefit from the Office Extend functionality?Many Thanks

Hello,I am trying to acces a new aironet 1142n. I have tried to access the CLI and get into config, it comes up that config is not supported.I try and get it an ip address from my dhcp server, can not access it that wayI have tried to telnet to it, i...

Hello,I am using WiSM controller. I have several 1240 APs. Today i am trying to add 1250 AP in WiSM but its not working.Can anyone help me on this?ThanksManish

Hi Guys,As what Cisco describe in their release notes 4.1.191.24M, this software is for 2100 Series WLCs, but when my WLC2112 is loaded with version 4.1.191.24M, WLC management tells me that only 6-APs are supported. Is this just a cosmetic error? (p...

I have an HP 8000 Elite sff that will not boot after installing the adapter. I am running XP sp3. As soon as I remove the adapter, it boots fine.???

Hello,I have a question about WDS.The only authentication method that is available for WDS AP to authenticate the infrastructure APs is only LEAPor we can use another EAP protocol? For example EAP-FAST?Thanks in advance.

As we transition buildings to our lightweight infrastructure we're installing new autonomous 1142 APs to fill in gaps and swapping out older 1242s with autonomous 1142s.  What we're seeing is that some of these APs, running the latest IOS code availa...

Hello,Is it possible to query a wireless access for the list of clients it can "see" ?I'm looking for a list of MAC addresses (or some ID) and the signal strength.Can you suggest an access point that can support this?Ideally I would like to perform t...

I will be staging Cisco 1522 outdoor AP in our LAB and I need a RF terminator for the 2.4GHz and 5 GHz antenna.On my recent training, the instructor mentioned using a RF terminator when staging the Cisco 1522.I searched the internet and found this sp...