Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Everytime I change the role from root to non-root the radio and software change to disable. I have the infrastructure set on the same ssid. I have changed with the GUI and the CLI. Help please!

wcs

hi! we r plaaning to deploy wcs in our environment. I would like to check whether WCS has the feature to monitor the APs connected to the WLCs? eg. If one of the AP is down....is there any indication in the console or msg/notification prompted to the...

dkblee by Level 7
  • 1144 Views
  • 5 replies
  • 0 Helpful votes

We are looking at upgrading a wireless network to for 802.11n. If we upgrade the 4402 WLC to support this, would the older AP1010 access points support 802.11n wireless?

swakelen by Level 2
  • 912 Views
  • 2 replies
  • 0 Helpful votes

Resolved! WLC Upgrade Info

Does anyone know where I can find info on 1030APs last 4402 controller release. I'm planning on upgrading my controllers and I believe release 4.2.207 is the last for the 1030s. 4.2.207 is where I want to go next so, when we get our new APs we can ju...

Hi,I need to configure AP with WLAN controller for guest access. we have 2 vlans. vlan 1 - guess vlan (internet only access) and vlan 2 - all access.while configuring wlan controller. which vlan should i configure as native vlan? I have radius server...

irfanrayma7 by Community Member
  • 2217 Views
  • 6 replies
  • 0 Helpful votes

How to ensure maximum client compatibility and stability in 802.11a/b/g/n networks?I am running a Wireless network based on the WLC 5508 6 SW version, (with WCS mgmt) and 1142 APs. I would like a broad variety of clients, old G clients and new N clie...

larsaschim by Community Member
  • 5792 Views
  • 7 replies
  • 0 Helpful votes

HelloI trying to deny mgmgt via dynamic interface on my WLC 5508. I have disabled both mgmt via Wireless and mgmt via dynamic interface, but i still can do ssh mgmt to the dynamic interface ont the controllerSomeone who can help me with this ?Regards...

HiI'm planning to move to a newer WLAN controller and is currently running some trials with our some of our currently installed AP1010. The plan is to reuse the AP1010 and fill out the gaps with AP1130AGs. The AP1130AGs are joining the WLC2125 ok but...

Hi.We have some 5508 controllers with and 1142 APs + web authentication using ACS.  Ours is a Conference + Staff utility where we want our users to remain authenticated as long as possible.  To this end I had modfied User Idle Timeout to 90,000 secon...

manandhar by Community Member
  • 1773 Views
  • 3 replies
  • 0 Helpful votes

I am looking for best practice or recommendation on which Wireless Security to use for our IP 7925 phones.  We are only starting with about 10 total phones.  They will probably stay local to the building they are in, so they will not be roaming betwe...

fasteddye by Level 4
  • 1725 Views
  • 7 replies
  • 0 Helpful votes

Looking for a troubleshooting guide for wireless clients, comparing RSSI and SNR values when connected to LAP(s).Currently using Cisco WCS 6.0 for troubleshooting wireless clients.Please advise.Thanks,Colm

colmgrier by Level 4
  • 21621 Views
  • 10 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card