Wireless

HiI am new to using the cisco lobby ambassadorThe problem I have is I need to clear down the database as the CLI is staying it is full (2048 users) I have deleted all old users and rebooted the box but it will not clear the old users, is there a way ...

hi! do the wireless controller 5500 and the cisco AP have the feature to allow access to an SSID only if the client's MAC or IP or name is registered with the system?

I followed the cisco documentation for setting up the WiSM. Controller 1 is up and fine. I see in DHCP bindings that Controller 2 is getting an IP Address and when I "session slot 9 proc 2" it tried to connect to that IP Address but on a "show wism s...

I was wondering if anybody has been able to implement RRM using the 6.x.x.x code and had a good experience using it.Thank youVic

I followed the documentation for setting up the WiSM. Controller 1 is up and fine. I see in dhcp bindings, that Controller 2 is getting a DHCP address and when I "session slot 9 pro 2" it tries to connect to that dhcp address, but on a "show wism sta...

I have several 1841s with 3G HWICs.  They are connected fine and have been running services at the roadside for a couple of years.  Does anyone know of a way I can find out the sim number of the attached sim without going out onsite and powering off ...

Hi All;            Is there any configuratin in WCS to make the AP in sleep mode or monitor mode,  if there is no cleints associated with that AP. Once the client joined in , the AP should wake up. I heard that ther is some opton in the WCS. Please s...

Hi,I am considering upgrading our WiFi APs (old Aironet 1100 Series) from our headquarter offices (25 users on large areas).I have contacted a Cisco sales rep and have been recommended the AP 3500 series with clean air and n technology.A few days lat...

Hi All,I am using Cisco 877W to provide wired and wireless conectivity to my users. We are having issues with the router refusing wireless connections after a certain number (most likely technical restraints), because the physical infrastructure is f...

Hi,In one document I see the following:Cisco 4404/WiSM controllers can support 125 simultaneous Web Auth Users logins, and scale up to 5000 web auth clients.Cisco 5500 controllers can support 150 simultaneous Web Auth Users logins. What about Cisco 2...

Hello,I connect first access point wap 2000 to router WRV200 by wired.second ap wap 2000 as repeater. Third AP as repeater.  its work but connection isn't stable.many packets are dropped and internet signal is bad.First ap work on channel 2 and wpa s...

I am having an issue with DHCP on our CAS 4.0.0 server.  I need to expire a DHCP lease or remove it because the device is going to use a reserved IP address.  The challenge I am having is that this device is an Apple IPad and apparently these devices...

we want to configure our WLC´s only through WCS. as i saw in the configuration it is only possible to do a manual "save config to flash". this means that we loose the configuration on our controllers when a controller is rebooted in an uncontrolled w...

Hi allI have a wcs installed with Every thing functioning properly.I am trying to see the path on which the floor plan get stored in the server.I would like to know that "is it possible to take the floorplan from the server" or "where is the image ge...

Hello All,i am new for this product so i need understanding what is the differnce between Cisco Access Registrar and Access Registrar Directoralso i need help to to configure below1) Bridge Authentication using EAP-FAST. (Bridge model 1410)2) Externa...