Wireless

I have an AIR-AP1131AG-N-K9 access point that I convert to lightweight mode and connect it to our WLC. All is working fine however for some reasons it look like the 802.11a radio is not coming up because the it's not in the same regulatory domain.As ...

I have a customer concerned about the possible interference and I am looking for some documentation to put thier mind at ease.  Any thoughts.

Dear All,plz let me know if the below command is a valid command:Static (inbound outbound) gre <outbound ip> <inbound ip> netmask 255.255.255.255we are having one firewall on which we want to do static nat for PPTP onour local serverneed help to nat ...

I have a config file and need to copy it to a 1242ag IOS12.4, using CLI consoled into the AP it does not copy right for some reason. How do I copy the file over?

Hello,In one of our building we have a wlc 4402 controller with 50 1130 APs.This setup is mainly used for VOIP Wireless with a 7921 phone.I need advices on how i can fine tune the APs to obtain the very maximumcoverage for the 7921 phone.thanks

hi,can someone advise on which LAP hardware platform support for Cisco videostream (reliable multicast over wireless) and cleanair?For AP 1132 and 1232, we are converting them to lightweight and appreciate if anyone can advise if AP1132 and 1232 supp...

I am reading a section that says that when you change a power level from 1 to 2 for a specific AP, the power decreases by 50% ans so on. My question is: If FCC says that transmit power should not exceed 30 dBm (I guess that is power level 1 in the AP...

What is the latest version of Wireless Lan Controller (WLC) with average price? If its possible plz provide Access point price alsoI required 100 - 150 access point in our network.

How do I regain communication with WLCM in a 2821?I was trying to get this running and had gone through the wizard for the basic config and could session to the controller before discovering the IP addressing I used was in the wrong MPLS VRF. I did ...

Hi,i'm looking for help, because i need  to configure an WLC2100, and i would like to know, if it's possible to  connect directly the ap's to the wlc, or i will need a switch, to be  between the wlc and ap's.I say this because, when i connect an ap t...

Hello,I am new to the whole what do you say... Internet jig. Does one have to have an internet provider such as AT&T or Cox or any other provider to get the Internet access I need, or can I just buy one of these Vallet things and be done with it?An a...

HiI've got a Cisco Aironet 1131AG AP and I am getting the Red-Orange-Green cycle of lights on the front. I have a feeling this might be to do with bad flash of some sort.I have a DB9 -> RJ45 cable and I'm able to connect to the AP using PuTTY. The AP...

I am using AIR-AP1231G-A A's, any suggestions to fix this problem? I really appreciate your help.

Hi,I saw a few discussions on WEBPASSTHROUGH and i need confirm the following.1- With WEBPASSTHROUGH can i redirect the users to a web page after they click the accept button?2- If yes, do i need to use internal, custom page or external server3- Do y...