Wireless

Can someone tell me how to make a goodbackup of the database on the Cisco WCS, version 4.2.110.0 and then move thebackup file to my laptop.  I am going to upgrade the RHLE and the WCS software.TIA

I wanted to post this as it's own question although it is posted already under "Ask the experts".We've added a secondary DHCP server to our network so that if one fails or is taken down for maintenance, we don't have a gap in service.  I need to add ...

Hello,I´m working on a wireless project that uses some LAP´s 1250, 3 controllers 5508 and a WCS software to manage everything. In one of the areas there are a lot of users, around 90, this area has 6 LAP´s. Some of those clients frequently migrate fr...

I am trying to calibrate a new install that has 1 x 4404, 1 x WCS , 1 x MSE , ~50 1142'sI have everything installed and it all works but everytime I try to calibrate the wireless using Cisco Context-Aware Service Configuration GuideRelease 6.0 Chapte...

We had an outside consultant install our WCS several years ago, recently I was asked to change the campus map from the Google satellite photo to a drawing we use on our website. The question is, can this be done without losing all the building inform...

Hello,is there a way to access a lobby database on WLC by telnet?Where can I find CLI command relative to lobby ambassador management?Thank you very muchJohnny

Hello,I would like to ask you a question related to the WCS, I have the version 5.2.130 ..I wonder if it is possible that when I look for a client that is associated to some WLC, selecting the client, I get four tabs General, Statics, Location and Hi...

Dear allWe have 2 wism as well as Anchor controllerGuest users are getting ip address from anchor controller.We had created DHCP scope on anchor controller itself.We had opened particular ports to communicate between guest controller and inside contr...

Hi to all,We have issues where clients randomly get disconnected from the wireless network, i have a 4400 WLC with the version 4.2.176.0 and suddenly users are getting disconnected, what i've noticed is that the users are attached to one access point...

heyExpert i have to set trasnmit  power 100mw on my Access point i have 1242 AG 1252 AG  how to set 100mw trasnmit power kinldy guide me aslo i have to conduct WIPT survey to set a tranmsit power of my device should i configure it on AP or on my cisc...

Hi,I have 2 WiSM module on 7609-S Router. The IOS i am using 12.2.33 SRC6.Does this IOS support WiSM?In sh module i can verify that this card is been recognized by 7609. When i do a "sh etherchannel summary" i can find 4 Etherchannel created  by dafa...

Hello!I got Cisco 1812 router without wifi and my goal is to upgrade it with minipci WiFi card but I don't know what cards are supported. I already got antennas and connectors but two atheros AR5212A AR5002x cards I tested locked up system on boot (l...

    We are in the middle of a company wide LWAPP conversion .   Ever since going from autonomous to LWAPP  via  WLC's and WISM's clients are occasionally dropping their sessions and we cannot pin it to anything in particular . Has anyone seen this or...