Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hi,I have installed the AIR-AP1131AG-A-K9 ,it is connected to a Cisco 3750 PoE switch,the ISP Router also connected to the same switch.It is woorking fine....all of a sudden it is hanging up,no user is able to access the Internet.That time if I plug ...

what will be the best recommendation of AP to use for 7921 IP phone. and is there any restriction on how many phones can register to this AP and how many calls it can handle

Hi guys, I have a dilemma which LAP to use inside a new building. I couldn't find a good comparison in the official documentation, so it will be of great help if somebody can give me a piece of advice and share his experience. I wonder what is the di...

glakovski by • Level 1
  • 3983 Views
  • 6 replies
  • 0 Helpful votes

I need some help in determining if we are experiencing a bug or a configuration issue. Let me start by giving you details of how we are set up.We have a WLC 4404 running 5.2.178.0 at our corporate office. Our remote offices are running a 1242 AP in l...

smoyer by • Frequent Visitor
  • 1171 Views
  • 2 replies
  • 0 Helpful votes

Folks, Is it possible for the SSC client to connect to two networks at the same time? it seems it does have an option for connect and connect exclusively, I am not sure what the difference is.

tpahuja by • Level 3
  • 897 Views
  • 0 replies
  • 0 Helpful votes

Hi everyone.I'm running WCS 6.0.132 with WLC 6.0.182 and I'm trying to build a Lightweight AP template to assign NAME-VLAN mapping on different AP running H-REAP.When I create the new template I setup AP in H-REAP mode and then enable H-REAP/REAP con...

Hi,attached is the output of "show country supported tx-power" command in WLC6.0.From there you can see the max tx-power for each country. From the output, u can see that most of the tx power is 20dBm for b/g. However, in the CCO doc "channels and ma...

e-chuah by • Level 5
  • 1272 Views
  • 3 replies
  • 0 Helpful votes

GentsI configured an autonomous access point as being a repeater to a root one. I ping the root from the repeater and it is showing as connect. however,the wireless coverage has not been extended?what is the problem?

eliesbat25 by • Community Member
  • 540 Views
  • 0 replies
  • 0 Helpful votes

I downloaded the USB-Install-7921-7925.1-0-2a.exe from CCO. I tried to install it but I am getting a Microsoft Logo failure message. The instructions said I would see that. Per the instructions, you can say Continue Anyway. When I get my error I don'...

by • Not applicable
  • 2076 Views
  • 3 replies
  • 0 Helpful votes

Hi,Can anyone tell the detail proceture/doc to remove software version 6 from a WLC 4400 and install a lower version of 5.1?Thank you!

forrestermu by • Community Member
  • 1132 Views
  • 4 replies
  • 0 Helpful votes