Wireless

We currently have 3 1252 APs in our building and they worked great in mixed mode.Today, two laptops in our office area connects to an AP in the warehouse instead of the nearest one in the office.How can I force or configure laptops in our office to a...

Hi,The communication between AP and WLAN Controller is ( Data and Control ) UDP. Source port 1024 and destination port 12222 and 12223. Actually which device listen to which port or both should listen as control and data can be generated from both th...

Hi I need 24 vlan switch 2960g ---- 1252ag-root-bridge ---- 1252ag-non-root-bridge ---- switch 2960g, doesn't work all 24vlan. Aironet is support only 16 vlan. Please help. Sorry my bad English

I need to move my guest WLAN's webauth page from its server-1 to server-2. It has been working fine with the guest WLAN anchor controller configured to do webauth. But when it is configured to go to server-2 -- I basically just changed the "External ...

I would like to setup an AP in sniffer mode but wanted to know if the would not provide wireless connection to client while in this mode ?Thank youVIc

Can Aeroscout T2 tag be used with CISCO 2710 readily?If not which software components need to be installed in CISCO 2710 for that?

When a client is redirected to our web authentication page, the WLC sends a TCP RST back to the client and 'Page Connect be Displayed' comes up in Internet Explorer. The following is displayed in the message logs on the WLC:Jun 01 09:25:04.876: [WARN...

Hi All How should I mount an AP-1131AG for the best coverage area? vertical(wall) , Horizontal(ceiling).Thank you.

Hi allcan anyone tell me what the following means, what is preamble, short/long?what is a good signal in -db ? and why is it a minus number?what about noise? should we be looking for a minus number? is anything above 0 bad?also what about gains, what...

Hi, The custom web-auth is not able to test preview from controller, but it is able to display fine from the actual Guest SSID where guest are connecting from.Version 4.1 able to test preview but not on the later newer releases.Any ideaThank you

I have an AP connected to one switch that shows up in the list on the controller when plugged in then almost immediately disappears. I have tried different ports on that switch, looked at VLAN config which appears the same as other switches where aps...

Is there a way to limit the total number of client on and ap?We have a client with a small school using the 526 controller.Aggressive load balancing enabled but we cannot change the window size, not that it matters a great deal as the clients seem to...

I have 1310G with 12 dbi external omni antenna, an 50 mw powered.Which value I need to enter Antenna Gain(dB): field in the configuration.Thanks?

We have a special engineering release of this code that Cisco gave us. We were having some issues with the internal web re-direct and they offered us a fix. I was wondering if anyone else is using this code and is it working properly.