Wireless

4400 series WLC with 100 supported AP's. present capacity is 62 active AP's but summary only shows 48 active...Why???????

dear all,is there any way to automate the following cli command through snmp write operation:netuser add test123 abc.123 wlan 3 userType guest lifetime 3600 description "guest test123"I would think the WCS is entering this information into each WLC t...

Does anyone know how to tweak the association time for a 4402 controller with Windows Zero Configuration client.Our users can sometimes wait up to 30sec to attached to the WLAN? Can this be tweaked on the controller or Client?

I dont know many people using ACS Express. Actually, I dont know anybody. How do you like it. Have you had any issues using PEAP? I am thinking about getting it. Do you need a CA for PEAP. I know with ACS Windows you dont need a CA. Does anybody have...

Hi all,I understand that Cisco Secure services client has this feature.However I need competitor info about this ? I know that Juniper Odyssey also does this.. but howabout Checkpoint or Websense Endpoint Clients ? Anyone has any document or info ? T...

We have a situation that we need to implement WPA2, AES with PSK on our WLC. If I put a complex passphrase of 63 ASCI characters, how safe is my wireless network? After reading multiple forums, it seems that is quite safe, even if this setup is desig...

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!...

Hi i converted a 1252 to LWAPP with the upgrade tool, but when the ap restarted with the ligthweigh image the access point does not accept the default enable password "Cisco", before upgrade to lightweigh image the enable password was "Cisco" too, no...

We've been happy w/ 4.2.176, but would like to upgrade to 5.2.178 to take advantage of the AP failover priority feature.Our SE told us a new MR release will be out in June, but we can't wait for that long.If you're running 5.2.178, please share your ...

I have a 4402 that was in demo status in my lab. I then moved it into production. While there were only minor changes such as IP, DNS, hostname, etc. to the 2710, WCS is a fresh install on another machine. When I attempt to synchronize the same 2710 ...

I'm researching a little into wireless troubleshooting and I'm starting to get a little confused about the differences between several modes available on Cisco access points. The ones I'm looking at are:- monitor mode- sniffer mode- scanner modeI tak...

Has anyone got the ANT5959 documentation that comes in the packaging. I am interested on how the ceiling tiles should be cut to allow this Antenna to fit flush against the ceiling.

Hello , We want to rent the internet access service to the houses which are provided to employees. That's why we need bandwidth limit and billing system solution. There will be also a guest users in the network. Could you give me an idea , is it poss...

My customer has a Cisco WLC with version 4.2.112.0. They want to incorporate NAC but, they were told they need to have version 5.1. But. when they review cisco IOS page, it says they should be using version 4.2.112.0, which is the version customer al...