Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I have new Cisco Aironet 1200 AG Series.(S/N: FTX1244B5CG and M/C 0022901B8436) Cisco IOS 12.3 (11)I have 192.168.1.0 /24 networks By default AP into lightweight modePl tell me step by step how to convert my access point from lightweight mode to auto...

dinchavan1 by • Community Member
  • 2579 Views
  • 2 replies
  • 0 Helpful votes

Hi Forum,Just to find out a little more detail in regards to the guest account created for web authentication using Ambassador account.1) If the authenticated guest did not perform a proper logout, what action will the WLC take?2) As such, is there a...

damiangoh by • Frequent Visitor
  • 718 Views
  • 1 replies
  • 0 Helpful votes

Look for any input or experience on how much DB loss to expect from inside a clean room. We are modeling for quite a few so was looking for various experience as the materials for the rooms may vary. Also Signal Quality if an AP is placed inside the ...

I can use our 1131AG that is connected to a Linksys switch then to a 2811 running CME for the 7921 phone but cannot reach the internet.Do I need to set up VLANs for this or should it work?I can ping "outside" from the router but not the AP. I can pin...

ronald.eddy by • Community Member
  • 1262 Views
  • 4 replies
  • 0 Helpful votes

We have a AP1131AG that has 2 ssid's set up, one for GuestNet that is broadcast and one that is not broadcast that is for the 7921 phone.The phone works fine with the CME, can make and receive calls fine.But the GuestNet ssid can only connect locally...

ronald.eddy by • Community Member
  • 969 Views
  • 3 replies
  • 0 Helpful votes

I am trying to understand what happens to a client when it is connected to an AP that changes channels via RRM. Does the client follow to the new channel or does it find an AP on the same channel it was talking to the AP before the AP changed? Will t...

c.fuller by • Level 4
  • 1268 Views
  • 1 replies
  • 0 Helpful votes

I cannot not get any settings to hold on a new air-ap1130AG standalone AP. Express Setup does not save any settings. The SSID Manager does not have the <NEW> option available and when I set them in the CLI they never appear in the web interface.

chris.long by • Community Member
  • 1531 Views
  • 1 replies
  • 0 Helpful votes

I'm aware of the process an LWAP AP goes through when a cold boot is performed, specifically dealing with 1130 access points. I've noticed that when using the reboot command in WCS, the process is much shorter than a cold boot (unplugging the AP from...

licopeland by • Community Member
  • 1965 Views
  • 1 replies
  • 0 Helpful votes

Hey all,We had a bizarre problem this morning with our wireless APs. All APs across two management subnets went down - 58 on one and 44 on the other. They are mostly 1231G access points. During this time, they were not reachable via ping, WLSE could ...

jeff.kish by • Level 11
  • 2895 Views
  • 15 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card