Wireless

I'm unable to recover the IOS on a 1242AG AP. I've followed the instruction on holding the mode button, starting a tftp server, setting the tftp server 10.0.0.2, rename file to the .default etc.. The ap connects to my tftp server, but I get file not ...

Hi allIf I want to upgrade my cisco 1200 access point to later code, but when I try it, it says no space left on device.what do I need to dothe files on the device are:config.txtr0.rcoreprivate-multiple-fsc1200-k9w7-mx.123-8.JEAprivate-configenv_vars...

Good afternoonI need to know how to configure a WCS for real time sending email when for example the interface radio of a access point associated to a WLC monitored by a WCS is down or has a problem.regardsAriel

Having trouble getting started. I can get the ip set. Then ping successfully. Open my browser and enter the new address - and get connection interrupted.I'm low tech - just trying to set up an access point with no security.

Both boxes are running a linux kernal. Can a WLSE be used as a location appliance ? Reuse of a apliance that would have other wise been scrapped.

I have a 526 controller and 4 521 APs on my LAN that I want to upgrade to LWAPP. I am using CCA and all the help says this should be a point-and-click type of thing. However, when I try the upgrade the CCA asks for an image I don't have and can't fin...

The documentation is a little fuzzy on what is supported. Does anyone know if H-REAP will work with the 1131G Access Point?

Hi,we just install a solution with 10x AP1131ag controlled by a WLC.We setup different WLAN with different authentication settings (web authentication, wep, wpa-802.1x).We notice that the radio signal power is really poor and even if we install many ...

HiToday I reinstalled the image in a cisco access point, however since that I cannot use http to access it, it comes up with a screen with very basic commands. What do I need to do here?cheersCarl

I seem not to be able to convert a 1252 from LAP to Autonomous. Anyone know if any issues with performing this task on the 1252?We are using the following document.http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/l...

Any ideas what is causing this particular message in the logs of our AP's.It only seems to affect the odd user, but always the same user getting kicked off. I have tweaked the countermeasure to stop everybody getting dropped, but the cause of this is...

I used AirMagnet Planner to place 1242 APs in warehouse using 35mW and -65 dBm cell edges with 20% overlap for 7921G phones.I plan to use RRM and Dynamic Power Levels. However I noticed when manually setting the power I can choose, 1 thru 5. With 2 5...

We have over 150 AP's installed. 1. I am noticing the below type of PING times from various clients attached to various AP's at different locations. Very few locations r reporting <2ms. Reply from 172.26.5.111: bytes=32 time=106ms TTL=127Reply from 1...