Wireless

Does CISCO have an 802.11n point to point solution

i have 9 antennas and i need how many users support each one.

So supposing I have a LAP that I move from one WLC to another WLC on a different subnet. I reset this very same AP to factory settings using the mode button, when I attempt to join to the 2nd WLC I have issues with the AP retaining its previous IP se...

I have a WLC2106 with 6 APs model 1240AG. An application uses port 11050 UDP for license management. The client send a broadcast on this port looking by the server, because this information is NOT passing through, the connection can't be established....

I have a customer who has a point2point wireless setup using a 1300 on either end. users are not associating with these devices. is there any way to filter end users (based on MAC address) on either side of these using just these devices - and possib...

I recently purchased a cisco AIR-AP1252AG-A-K9 stand alone wireless access point to serve guest users at a reference area. In trying to get this working, I've used the "debug dot1x all" and "debug eap all" commands, but can't seem to see any info. fr...

I have setup Option 43 on MS DHCP server following the Cisco documentation but the access point does not discover the controller it seams to be ignoring the DHCP option. The access point and controller are on seprate VLANs. Anybody have any ideas why...

Hi,is there a way to use a DMZ WLC to use the guest access even if the DMZ WLC is not in the same mobility group as the internal WLCs are ? Has there to be a mobility group over all WLCs that this can be handeld ? Thanks Dennis

I found from the internet that when a client device associate to the wireless device, the wireless device sends the maximum power level setting to the client.1) Why the associate AP need to send the power to the client? 2) What happen if the power le...

Hi,I am attemping to configure Infratructure authentication for WDS and WPA/PEAP Client authentication using ACS 4.1(1) Build 23 from an Aironet 1210 running IOS 12.3(8)JEC.I have a production ACS server that has both LEAP and PEAP enabled under the ...

Hi,We've installed an Aironet 1300 (with external antenna) at the top of an 80 foot mast. Before installation we configured it with a static IP, setup its SSID etc etc. We also tested connecting to another WAP etc. All setup was done using its web in...

I have couple WLAN Controllers. I would like to set primary and back up on LWAPP. Do I have to create DNS name for Primary Controller Name, Secondary Controller Name? if yes, which IP do I suppose to point to? (Manager Interface IP or AP Managee Inte...

The 1250 Series Access Point, is it a Dual-N Band Access Point (where both 2.4GHz and 5GHz work in 802.11n) or a Hybrid Band (where 2.4GHz work with 802.11g & 5GHz with 802.11n) or a Single Band (either of the modules work at a time) device??What do ...