Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hi,There are lots of reports available in WCS. Can anyone give figures what are the common reports that WCS admin will need to enable and schedule regular reports?Leon
Hello, we are trying to create a Web Auth SSID using Active Directory to authenticate the users. Does anyone have what the fields on the WCS map to in AD? Gregg
We have deployed Wireless in a few offices as a proof of concept and we have started to get the following alarm at one site: The AP '00:1f:ca:2e:59:a0' with protocol '802.11b/g' on Controller '#.#.##.#' received a message with a large NAV field and a...
Hi all, I have wds configured on my 1242 acces points, I can see on 2 of them, they are configured with "use this AP as wireless domain services" ticked and a priority of 250 and 255 on the other. However the other access points do not have this conf...
I'm not able to establish with console of the AP1131AG. there is no response on CLI.and, the AP shows the red led on radio and no light on the other leds.Is this firmare problem? or any other clues of this failure?Thanks.
Do all Cisco Aironet products support multiple SSID with VLAN?
Howdy!I can't see any mentions of 1100 series in docs for 2100 wlc, does it really mean, that 1100 series can't connect to 2100 series?http://www.cisco.com/en/US/prod/collateral/wireless/ps6302/ps8322/ps7206/ps7221/prod_qas0900aecd805aaa9c.htmlQ. Wha...
I have several 1242's in my environment using Radius for EAP authentication. I have a small number of Mac users who cannot get connected via this method... Can someone offer me an alternative configuration....I basically have a red and a green SSID. ...
Hello,i have installed the Spectrum Expert Software on my Dell Latidude D520 Notebook.The Card ist correct installed to.(Control Panel --> System --> Hardware)But if started the software the software hang up and do nothing.I can stop the software wit...
Dear Netpro Community,I would like to know whether the following OID talks about the number wireless clients joining the AP at which OSI layer.Rgrds,Beno
HI,I Have (3) AIR-LAP1131AG-A-K9 working with a SSID each one. I wanna to configure an unique SSID and roaming between thats APs without use a controller. The 1131 AG Devices support roaming ? and yes, how configure it ?Thanks
Hi All,I have four APs that when I powered on individually, they went into the downloading state and rebooted, now have the mac address APxxxx.xxxx.xxxx.cisco.com and can see this on my switch and cdp is working, but has not joined the controller?I k...
What's difference between AP Transport Mode LAYER2 and LAYER3???
I have 8 1131AG access-points (autonomous), with 50 user connected. All users use IPCommunicator.The interface utilization of the access-point is 3%, but there is a big jitter when making calls (in WLAN).What could be causing the jitter?
Good Morning,We are having issues with the WiSM modules dropping their service connections. We have two WiSM modules in two separate 6509 switches. WCS will first report:Keepalive messages are lost between Master and ControllerI then login to the 650...
