Wireless

I'm running an WLAN with a pair of ACS3.3(2) servers and 1200 series APs. I use AES encryption and Peap MS-chap authentication.Everything was running fine until I renewed the SSL cert for the two servers. After the new cert was installed a large numb...

I had setup wireless network withwlc4402,cisco AP 1310.1131 and 1242 and Cisco acs 4.1.My problem is only 30 clients connect through Cisco AP 1310 at a time.I can not connect more than 30 clients at a time.What is the issue in wireless network?please...

Can I import existing configuration from an autonymous AP1231 so i can use it after the upgrade process to LWAPP ? We are using the Wism (WLC).

Hi, one small question about Aironet 1200 model, in a room i will use one 1200 for AP-indoor,but im wondering if i can also use the same AP with one atenna to outside, AP-outdoor.I will have two wifi clouds? one inside another ouside, with only one A...

I have a network with 75 Ap's on it I am registering 65 of them on the WLC and the other ten I have 6 that when I search for them in the WCS I find them and they say that they are connected to the correct controller but the WLC doesnt show them conne...

I need to support and configure the Cisco APs. May I ask what are the additional certificates that I need other than CCNA in order to support the APs.

Hi list! I read the security configuration for the 4400 series but cannot seem to find what I am looking for. Does anyone know to configure clients associated to the APs to not see each other? Like clients should not be able to ping other clients or ...

We have a 4402 controller running 5.0.148 code without issues that we know of.We recently installed a WISM module in our 6513. It was running 3.X out of the box. Does that mean it has been on the shelf for awhile? Are there updated WISM on the horizo...

Hi all, I have recently setup a WLC 4402 with LWAPP 1242AG's. I have a guest SSID setup that gets fired straight out to the internet. I enabled the Lobbyadmin feature but would like to know how other people have handled getting reception to distribut...

Hello,I'm getting ready to move from a linux server running our current WCS to a new windows server. I already have the WCS installed and was wondering how to get my licenses and such from the current WCS to the new WCS. I havn't really found any doc...

DearsI am trying to change gateway which was previously configured wrong.But facing error.Below is command which i am using and error facing.configure interface address managent IP-ADDRESS SUBNETMASK GATEWAY"Request failed - Active WLAN using interfa...