Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hi all,I'm not familiar with Cisco new AP and have a question for all. Is it possible to have one access point authenticate domain users on one vlan and then outside users on another vlan without authentication? For example, if i am as a domain user ...

hi, I have problem with access point air-lap1242ag-a-k9 work with lan controller air-wlc2106-k9. the connection works well during a time but soon it is lost during few minutes and soon it raises automatic, this process repeats the day throughout. I h...

mavega2005 by • Community Member
  • 593 Views
  • 1 replies
  • 0 Helpful votes

Hi,On a daily basis, how can I automate the backup of my WLC 4402.On my switches and router we use KiwiTools.I saw the commands to do a TFTP upload, but there is a confirmation ("Start? y/N:") that won't allow that to work.Any suggestions would be ap...

svillardi by • Level 2
  • 1173 Views
  • 5 replies
  • 0 Helpful votes

Hi,New to enterprise wireless. Just installed 20 WAPs 1240s and 1 WLC 4402.The users are using a radius server to authenticate against the AD.How can I get the logon scripts to run?Thanks,Scott.....

svillardi by • Level 2
  • 1289 Views
  • 5 replies
  • 0 Helpful votes

Hi all,Can anyone who got very good experiance in configuring WLC & LAP present a documentation on following aspects:1. Configure the Wireless LAN Controller for Basic Operation and Registration of LAP to the Controller.2. Implementation of Vlans on ...

Gurus, We have a wireless solution provided in a hotel for almost 800 APs with c6500 + WISMs.On each floor the AP are in the lobby and not in the rooms, the wireless data is fine but IP phones are disconnecting or the voices are choppy.Initially the ...

I have 7921 phones along with 1242 LWAPP APs. I have noticed the phones resist roaming to an AP that is closer (stronger signal). I did some testing on some APs that did not have any other associations. What I found was the phone would cling to the A...

jcvanwyng by • Level 1
  • 1925 Views
  • 7 replies
  • 0 Helpful votes

Hello all I have an 1240AP on my desk and the power is set to level 1 (which is the maximum)We are in region EThe antenna is air-ant4941 2.2 dBi DipoleIf you look at the documentationhttp://www.cisco.com/en/US/docs/wireless/access_point/channels/lwap...

My customer is using AIR-WLC4402-25-K9 with 22 AIR-LAP1242AG-E-K9 AP. After WLC software upgrade to version 5.0.148.0 the syslog is full of messages:2008-04-22 00:00:20 Local0.Error 10.156.93.66 Apr 21 23:01:20.300 ccx_rm.c:2771 CCX-3-AP_NOT_FOUND: A...

fopravil by • Level 2
  • 1298 Views
  • 4 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card