Wireless

We are about to upgrade ACS from 3.2 to 4.1 and I understand the format of the PAC changes in ACS 4.x. Is this the chase, and will all users need to be provisioned with a new PAC?

Please let me know if my config is valid. Sorry i don't have visio's but from what you see, syntex , etc..does it look ok? do you see any problems with this. attached is the complete config for the ASAWeb Site Piece (External)access-list acl_inside p...

I am trying to update our Smartnet for our location appliance but can't get the serial number. It's supposedly printed on the bottom of the device or accessible via WCS 'Advanced Parameters' page. The appliance is mounted in a rack not easily moved a...

Having issues with a cisco 2950 switch that is feeding off of a lwapp 1242. The 1242 is connected through mesh to a 1510, I can connect to the 1242 throgh wireless and it works fine. I plug the switch or even plug the laptop directly into the 1242 an...

I have a Wireless Controller 4402 connected to one sw2960G.I configured the controller with LAG and the switch (sw2960G) with etherchanel.I connected the controller 2 distribution ports to the 2 ports of the switch (configured with etherchanel).It wo...

I am looking for a Linksys Access Point which supports follwoing features802.11 a/gSNMP support Vlan SupportYour promt reply is highly appreciatedcheers

Hi Guys,This is a little bit of an odd request however I need to allow a sync routing due to some legacy routing to pass through my ASA.I have allowed IP any any between the particular hosts involved to allow for high ports etc.. However the ASA is t...

I am trying to get a AIR-LAP1252AG-A-K9 to associate to the 4402 with no luck. It shows up in CDP neighbor but not as an available AP. Please assist!

The administration of WLC is lost and we feel the need to boot the WLC to recover the administration once made the reload the WLC loses all the mac-address filter, passwords, and users of visits created in the captive portal

Does the 2106 support local eap authentication (leap, peap, etc..)

Will I be able to centrally manage a deployment of 9 Ap's with justa WLC and no WCS ? Im not sure how much management capabilities comes with the WLC interface. Can some one tell me ?