Wireless

When I Have the WLSE set a WAP as a scanning AP. It causes the AP interface to continuosly go up and down. I have tried this on 2 1231 APs, and a 1242 AP with the latest and greatest software.My Wireless Lan Solution Engine is 1130 Release 2.13FCS Bu...

Hi all,My case is like as below:2 WLC, WLC-4402-25-1 & WLC-4402-25-2, are implementated. There are a total of 30 APs. In case that one WLC is down, the remaining WLC cannot cater for all 30 APs. Here is my question:Can i specifically set which AP can...

Can anyone shed light on how they survey for rfid, currently i survey to -75dB at 3 access points but I am ending up with alot of aps. any suggestions and explanations greatly appreciated

Hello,We have a problem concerning QoS and per-User-Bandwidth-Contracts. We use 1240 APs on 4404 WLCs with 3.2.50xx WLC Firmware.Our goal is to arrange some users into different QoS-Classes (than the SSIDs default QoS-Class) depending on RADIUS-entri...

Are there any brave souls out there that have upgraded to WLAN 5.0.148.0 and/or the new WCS 5.0.56.0? Observations? Gotchas? Thanks.

We have 1131AG's in multiple locations.One particular site is having problem w/ Intel cards.They can see strong signal from the AP's but can't pull valid IP's, or even if they can pull an IP, the connection would drop in 3 minutes.Initially this poin...

Hello everyone,I need some help here. I am currently working on a project with Centralized WLC deployement at a Co-Location Centre.My WiSMs are located in my co-location switches. The Co-location network is different from the corporate network (MAN/W...

We have two WiSM blades on one C6500 switch. We use WiSMs as DHCP relay pointing to central DHCP. Because of the lack of IP subnets, we want to use one /22 subnets for the two WLANs(same SSID) on two wisms. Anyone tried this? Any problems with this s...

Is there a means to configure autonomous 1121s to use EAP and use Microsoft Active Directory as the authenticator? Or will I need a RADIUS server?

The client is using NM-WLC in 2800 series routers. The WLC version is 4.0.219.0. I cannot perform an upload of the configuration file via the GUI, but I can do the upload from the WLC CLI. Also, there is no information in the WLC log files to indicat...

I'm doing wireless installations in several countries but I purchase APs and 350 Client cards from France. How can I change the regulatory Domain of a 350 client card to make it fully work for example in the US or in Japan?Laurent.

The manual does not tell me how to turn the radio on. The product ships with the radio off

Can anyone help me removing transport command from my Cisco Aironet AIR-AP1242AG-A-K9 1242 ?I want back to the default.I have reset it but didn't work Thanks in advanced.Best regards,Slhline con 0 transport preferred all transport output allline vty ...