Wireless

I have an old 350 series Acces Point running IOS 12.3.8-JEA. I configured this AP with WPA-PSK, and everything worked fine until a few days ago... My clients refuse to connect to the AP, while I didn't touch the AP. When trying to discover the networ...

hello. im planning on implementing indoor location tracking using LWAPs for triangulation and WCS as the software for configuration in addition to a WLC. want to check if this is a possible implementation. thank you. =D

I am facing a strange problem with 1242 APs amd Symbol wireless scanners and Zebra wireless printers. For the frequency channel I left the default config (least congested) and I had: printers working OK, scanners had signal flactuating. I changed the...

My 1242 AP's keep getting rebooted everynow and then. I check the traps on the WLC 2006 controller and these are some of the messages that appear right before the wlan freaks out and people lose connection. 3 times this happened and the wlan died com...

Our campus is configured with Cisco 1230 ap's and have begun testing with LWAPP conversion with a WLC on ver4 - I have begun reading that H-REAP is only available on 1130 and 1240 AP's at this time - Is there plans to allow H-REAP on 1230's? I would...

Setting up a 2006 wlc ver. 3 with a 1510ag-lap.Have gotten all interfaces to ping, management can see the Mac of clients trying to connect.I have set the tag for the vlan on the port. Tried setting the switch port to vlan and trunk mode. Everything w...

how do i recover the username and password to my wireless controller? it is a cisco 4404any help would be greatly appreciated!

I am running WiSM with ver 4.0.179.8 and I am getting these messages in the traps section of the WiSM.Does anyone know what they are and if I need to worry about them?

we have a secure wireless network that supports both WEP and WPA and requires users to authenticate (LEAP and PEAP both supported). APs are 1130 and 1210 using 12.3.8-JA. Setup works fine except when client wireless device has Ralink chipset (Dlink a...

I am currently using WPA2-spk. I want to add another layer of security. I know I could do EAP. I am also looking at mac authentication. But I want to host the mac list on an ACS server. Setting the the mac addresses on the ACS server is pretty c...

Gents, Does anybody know where I can download this software from ..? I have used it several months ago from meeting house when it was called AEGIS SecureConnect 4.0 ( now been acquired by CISCO) .. from The Cisco software center is says unavailable...

Hey all, has anyone found the serial numbers of APs shipped before July 18, 2005, the date after which Manufacturer Installed Certs (MICs) were installed on the APs? I have found upgrading APs without the MIC (via Self-Signed Certs -- SSCs) to be mo...

Hi,what is the main difference between Cisco Aironet 1230AG and 1240 AG access points?My second question, if we want to buy a Cisco Aironet 1230AG AP with external antennas (2.4 GHz), this AP will serve both 802.11a and 802.11G (with 802.11g antennas...

I have a little doubt and I didn't find an answare at cisco.com. I whant to know which is the flow of the data in a Wireless LAN when you are using a controller? I mean, if I have a computer connected to wireless lan, when i get or send data through ...

Hello all,We have a Wireless Infrastructure already in place using several 1130AG WAP's. The authentication for the clients is done by setting the WAP up to pass the credentials to our Windows 2003 IAS server (RADIUS). The client side works fine. ...