Background, we are using a Cisco 1200 series AP with a G radio card. We have the AP setup to do 128bit WEP. The clients are all 802.11b clients. The clients will see the AP, will associate, but will not authenticate. The WEP key are all the same....
what i have npw AP1232AG, WLSM and SUP720. i,ve implemented wlan for our internal users, via fast secure roaming. Now i want to setup the connection for external users. i have a seperate internet connection for external users . what is the best metho...
Hi,In my ciscoworks I have some vtp views but my access-point is in the view NO_VTP. I would like to place in the company vtp domain but this doesn't seem to work . I don't have any commands , there is no vlan database on the AP ?How can I configure...
I have a network that has two 4404-100 controllers with approximately 65 AP's. I have a VLAN setup for WPA and ACS authentication, and the problem I am having is that I am dropping a ping or two when I roam from one AP to another. Is this something...
Hi all,I've never worked with the 851 on the wireless side of things and I'm having a really hard time getting this thing to let me connect with my laptop and give me an IP address. I just want to setup something fairly simple with an SSID (non broad...
hi,i have a 3 AccessPoints on the same floor. i always got below disconnected message in the logfilewhat should i do. sometimes a client cannot connect to WLAN at all? please advise#######################################rface Dot11Radio0, Station 0...
I have root and non-root B1410 bridges. The root bridges will show temperatures in the GUI. The non-root do not. They show a WARNING: No Reading temperature monitoring is at 'INITIALIZE' state. What does this mean? I have not been able to find a...
I have a couple of 1200 AP's with the G radio installed. We have several clients from various brands. Gateway/HP etc that have A/B cards on the client and are unable to connect to the 1200. It sees the SSID etc in the windows wireless configuartio...
I actived Management Frame Protection in WLSE with 1131 and ios 12.3(8)JA.when any wds find error with Management Frame Protection, do anynithing that reset all (with blue screen) intel centrino with intel wireless card 2200 at the same time.The nex...
How do i change the IP address of my AP 1200 access point through console mode ?i am able to plug in my console cable to see the bootup but i cannot go into config mode to make changes to my configuration.I need to change the IP address because i wan...
In my wireless domain, I'll have a WDS, with 40+ AP as infra client, and 50+ workgroup bridges as client to the infra AP .My question :1) Only need to enable workgroup bridge on the client, right??2) Do I need any root bridge ??Thanks.
Can anyone point to some documentation on cisco.com that explains the difference between a WLSE 1130 and 1130-19. When I do a show version will it display WLSE 1130 or WLSE 1130-19?
I have upgraded WLSE to version 2.13.After upgrading, "Unable to verify MFP configuration","MFP Timebase Invalid (bad SNTP), Device was not reachable via SNMP" these messages are logging so many on WLSE fault status. What are these mean and How to so...
Hi all,I do a lot of wireless rollouts most recently using Aironet 1130 AP's. I've been getting reports of intermittent connectivity - but nothing consistent, i.e for a while it works fine in one area, then doesn't, then does again. I've done all the...
