Wireless

Hello,I am going to deploy a guest access with WLC / WCS.In autonomous mode, it is possible to configure "pspf" to avoid that wireless clients perform files exchanges and so on together.Have we the same opportunity in centralized architecture ?I alre...

Where can I find the Demo certificates for eap-tls testing without having to set up certificates. The link listed in the reference guide is http://www.cisco.com/warp/public/cc/pd/sqsw/sq/tech/tcert.zip. This link is no longer valid.

Hi,My internet adsl and wireless connection are working fine under my Cisco Router 857w.However, I have discoverd that I did not configure properly my connection, it is totally unsecure, because, I can connect to it, via my ISP dynamic IP, also I do ...

In my unified wireless network i have WCS, WLC 4402 and 6 LWAP, we have neighbore company, and some of our employess try to connect to their AP's, is there any way to block my employess using WLC and WCS from establishing a connection to the neighbor...

When browsing to 1131 & 1242 via https, the password prompted for is level 1:"level_1_or_view_access"I would like this initial access to prompt for level 15 password or, at worst, level 2. Is there any way to change the level of initial access via ht...

Are there any Best Practices documents for the WLSE Express 1030 v2.13.1?I found many documents, but no suggestions. every time I start to set up a wireless LAN (1030, AP1200s, Active Directory), I get hung up on decisions that need to be made, but t...

Has anyone implemented this new firmware code? Any problems as of yet? I know it is fairly new, I would like to upgrade my two controllers as they are running 3.2.116...code to the latest code without known issues.Thanks.

Do any CISCO AP.'s support client mode?

I have an 800 series router that is getting "interface resets" fairly often. What would cause this? Also, I can browse all sites but Microsoft sites, any ideas of how to address these issues?Thanks

I just attempted to log into a 1231G AP that I have using the local account I created. I was connecting via HTTP. It didn't like what I was supplying for credentials. I then plugged in "Cisco" and the password "Cisco" and it let me in.I checked the c...

Hi Cisco,Will the exsiting range of Cisco AP's like the 1131AG support 802.11n in the future once the protocol is radified?thanksAllan

Hi,I use ACS4.1, link to a active directory database. I configured the laptops to use EAP-FAST to get a secure wireless link to our lan.If I use a manual pac, it works fine. But if I try to use the automatic pac provisioning, it doesn't work, always ...

How do you enable WPA2 with AES encryption on the 877w router? I can only enable WPA.