Wireless

I recently resolved an issue in which a non-Cisco client would not fully associate with Cisco AP's that had the "Ethernet Encapsulation Transform" setting on their radio interfaces set to 802.1H. Changing the setting to RFC1042 resolved the problem.M...

Hi, I have problem with configuration proxy mobile IP on Cisco aironet 1100 with IOS version 12.2. I have read, that I need to set Authoritative AP to get subnet map where are ip addresses and subnet masks of the home agents. I have only one AP and I...

Hi,I've an implementation of several Access Points in a big Warehouse/Production plant, and in a certain area, when doing a survey, I'm able to see 4 Access Points, this means that 4 are overlapping.How do I do to decrease the antenna power? or the a...

Is it possible to change the regulatory domain (country specific) of 1300 series wireless bridges through Software?

Dear All,I have a lightweight AP, how can I copy the IOS from the Leightweigh AP?Thanks.C.K.

I'm using WCS 3.2.51.0 controlling a WiSM with the controllers at 4.0.155.5. I'm trying to use the mapping features and create a RF calibration model. However when I go to add data points then enter the wireless MAC of an associated client and then p...

I am trying to set up two 1232AG Access Points as a bridged link between two buildings. They wish to use the "G" radio for data (VLAN 1 - native) and the "A" radio for voice. Both AP's have an IP address in VLAN 1 and are configured to allow VLAN 1 t...

I have a problem that is starting to drive me crazy!!I have an ACS server ver 3.3 on windows 2003. This authenticates users through our AD domain. I have other AD domains configured and everything is fine. I have recently had to add a new domain to t...

is the communication overhead greater for Peap than Leap? Recently gone from leap to peap over 802.11b wireless....experiencing slowless on wireless lan.Rgds.Harry.

Hi All,Wonder anyone encounter these! I have catalyst switch running RSTP+ connected to AP1200 with vlans. The switch port that connect to the AP is configured trunk in order to transport vlans. Odd things happen when link on catalyst switch fail, th...

We are a small community with line-of-site wireless internet service. We are interested in replacing this service with a wi-fi service that does not require line-of-site as it is expensive to install each user and line-of site is not always possible ...

I have a customer with Cat6500 and WLSM running WDS. The APs and dot1x clients can authenticate with the ACS server. However, we cannot get any accounting information. We have tried configuring the WLSM with the following commands:aaa accounting netw...

Dear all,We are using Cisco AP1231 Access Point in our office to provide the wireless LAN and we are using LEAP for authentication. Now, we would like to use WPA (with PEAP authentication) for the new notebooks. Is it possible for a single AP to use ...

This unit does not respond.after "boot" the only prompt i get is;ap:if i type en or enable i cannot gain access, it responds with Unknown cmd: en.here is a copy of what the boot looks like;ap: Xmodem file system is available.flashfs[0]: 17 files, 3 d...