Wireless

how to Integrate wire & wireless LAN in cisco 1812 router

Hi all,trying to make sense of the sh interfaces dot11Radio 0 statistics command .The Header CRC Errors are incrementing @ a much higher rate than CRC Errors, anyone know what this means.Also how much buffer space do the cisco 1100 ap have?.I maybe l...

Hi all,Our company just deploy the 6 x Cisco AP1010 with Cisco WLC 2000. In the WLC web console, I can see the user is connnecting to which AP in that moment. However, is there any way to trace the user assoicated to which AP yesterday? Thanks.Regard...

We currently support LEAP. I have successfully tested and configured PEAP on a test client using the same access point. The problem I discovered is that if a client is still configured with LEAP that it continues to authenticate. We would like a PEAP...

Help, I cant get the 3945 ABG card to work with our cisco AP using peap & chap. Has anyone have this problem. If so could you please help. Thanks

When I trunk my access points I lose the ability to manage them via telnet and http. To gain access, I must make the link to the AP static. Suggestions?Thank you

I have been unable to determine how to indicate wall mount orientation of APs in the WLC for the 1000 series (AireSpace) and 1131AG series access points.I can set the rotational direction they are pointing if ceiling mounted , but cannot indicate if ...

Hi,I have an interesting problem with an Intel 3945 A/G card, and my cisco APs.1. Given:Cisco 1100 and 1200 AP running IOS 12.3.8-JEATwo laptop, one with Intel 2200 MPCI Card, the other with Intel 3945 MPCI CardMicrosoft AD with IAS radius servera. 1...

Helloon the 3750 (WS-C3750G-48PS with 12.2(25)SEE2)Switch we have several different type of LWAPP accesspoint. In the cdp neighbor table in the switch are just the "old" airespace (1010/1020) ap with the right name visible, the 1131/1242 shows just "...

Hi,I have a Cisco Wireless Controller Model 4402 with 1131 Model APs. I am trying to get the APs to see the controller, but no success. I am using a Lucent QIP DHCP server (which I know very little about) and am thinking that I need to configure Opti...

dear gentlemen,i have one wlc-4402 controller and some clients. how to configure the netbios over tcp/ip in the controller, so that the clients can assiciate the network.thank?s in advance michael

Hi all,I followed the steps outlined in this guide:http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008070ba8f.shtml...of course I modified it a bit. And it all works, I am just a little confused at why it works if ...

I keep getting this message whenever I boot my WLC. I have the Date and Time set correctly but I'm not sure how to set the timezone. Timezone options are Delta: hours __ minutes__Daylight Savings Enable or disableThe message I keep getting is this:"C...

While auditing a client (using Kismet) I found that some of their Cisco APs have a <info> field in beacon packets. I'm trying to figure out where the data for this field is entered in the configuration. I do not have access to the configurations. The...