Wireless

Cisco Aironet 1200 SeriesRumor has it power can be supplied to these via an Ethernet cable. Can anyone point me in the right direction to confirm this?

HiI'm new on this stuff of Wireless LAN Controllers, actually we are trying to deploy a 4404 controller but we found it has four 1000BASE-T slots, we bought a SFP 10/100/1000BASE-T RJ-45 and we installed in the slot, but it did not work for a 10/100 ...

We're just getting started with a Cisco 4402 controller and multiple access points. We are working with the captive portal, and I am wondering if anyone knows if the controller (not an external web server) is capable of serving up different web pages...

I am working on WLAN design that spans single floor of a building with two data closets, an east and a west side.On each side of the building we are going to plug in LWAPP AP's, 1100 series, into our Cat 4500's In the data center, we are going to use...

I have two Cisco 1310 devices that I configured for Point-to-Point conection. One is configured as a route-bridge and the other as a non-root-bridge. I calibrated the radio signal using the "led calibration method" in install mode. The ap's are confi...

All Cisco docs talk about "trunking Vlans between switches when using the WLC. My customer is running Layer 3 and doesn't want to do trunking. Will the WLC still communicate with the AP's is we did say "tunneling" between the switches? In other words...

Hello.I am engaged in a WLAN project that use a Cisco ACS integrated with NT Domain for authentication and the Access Points used are Cisco 1200 series. All was going well until a user to start to share the WLAN as a repeater using a Windows XP and w...

Can the lightweight access points be controlled by WLSE or do you need to have a WLAN Controller?

A cisco 1010 that runs multiple Wlans which are connected to diffrent dynamic interfaces (with version 4.x aireos). Must that AP be connected as a trunk to the switch? And if yes does it then mean that for each wlan there is a different tunnel to the...

in aironet i`m unable to set a fixed channel in the 5 Ghz (because of eu dfs). However in airespace i can se the channel to manual override in 5 Ghz. What will happen when a radar turns up in the same channel,does the radio turn of as it is required ...

Hi guys,I have 10 Cisco 1000 series APs and 2 controllers in the same VLAN. How can I register 6 APs associate to controller 1, but the other 4 APs associate to the controller 2?Thanks,yytellmey

Anyone can perform the following (WPA with MAC authentication) on the latest IOS code ??

Dear SupportI have a Guest WLAN that uses web authentication via a 4404 WLAN controller and ACS box. It works but every 20 minutes the session times out and they have to re-authenticate again to get wireless access.We have other WLANs for phones and ...

Hi, I am setting up a WLC2006 with 2 AP1010's. I cannot get the controller to see either AP. When I place the AP's on a network with a WLC 4400, they are recogized immediately by the 4400 at Layer-2 LWAPP. Since the WLC2006 only works at Layer-3 LWAP...