Wireless

What is the procedure to do a "site survey" with a PTP bridge already installed? Distance is 2 miles, in excess of LAN adapter range. I believe I am getting interference (low rates and high CRC count) and need to identify the source.

HiAre there any MIB for check the interference or noise in an AP?Regards.

Hi Sir,I installed ACU 6.4 on my laptop. Whenever I would like to launch ACU, the following message appearsError message:You must upgrade your NDIS Driver to use all of the capabilities of this version of ACU!Attached are the screenshots of the error...

The ap1130 is rebooting every 5min. This is working on WDS infrastructure and EAP authentication. There is no error log message and no radio interference and low CPU utilization. We have upgrade 12.3(8)JA, but auto rebooting problem is not solved. Is...

I am trying to reset an aironet 1100 back to factory default. The only button on the bottom of the unit that I can see is one that says mode on it. Is their somewhere else where the factory default can be reset at. Thanks

Hi,I have to install a Cisco PCMCIA 350 card (AIR-PCM352) on a desktop PC running Windows XP Pro sp2.To do that I use a PCI adapter with Texas Instruments PCI 1410 chipset but it doesn't work because the system recognize the card as MTD-002.Is there ...

Hello all,I have a distribution center that we want to build a wireless infrastructure. After the site survey, we need to have 132 AP 1242ag non modular. I am planning to design using Layer 2 with WDS/WLSE since we only have cisco switches 3550 in al...

I want to set up a SSID for the purposes of identifying where our access points are. But I dont want it to allow anyone to connect to it. Is this possible?? Or not to allow any traffic to or from that SSID?

Can 11g Access Point support 11b client ?i have a Access Point AIR-AP1231G-E-K9. Users with a 11g client adaptor is able to login successfully, but users with 11b client adaptor is not able to login.How should i configure that AP so that 11b client c...

Hi,I am working on a requirement to phase in a migration from FHSS to DSSS based on the Aironet1240 for a outdoor deployment. However, the nature of the project requires co-existance of the two radio systems for a period of 6 months. Does anyone have...

I have a site in which I would like to configure my 1030 in REAP mode on my WLC4124. I want all of the traffic to stay local. What I'm thinking is that I create an interface with the local vlan at the remote site on the controller (40) then create an...

Hi, The Lwapp controller reports a noise/channel chart and an interference/channel chart.In the wirelles RF world, What's the difference between noises and interferences ? regardsCedric

We have 3 offices, like office A,B,C, A and B on same building but different floor, C is about 50 meters away from A and B.Room B is our server room; Internet connection, email server etc are in this room.We want to build a wireless LAN, just connect...