Wireless

i have implemented Wireless bridges between buildings , but i do not want that wireless clients can connect to the bridges configured as :role = rootas they are used only for infrastructure. I cant find infos on doc.can you help???

Does leap work with freeradius??

This is mostly a design question...I need to implement an open wireless access point for visitors who comes to our office for a few days or a few hours. i.e something simple to use for these people who are generally executives or clients and who do n...

Are there any significant differences that the 1400 will do that a 1300 won't?

I recently upgraded a select group of my access points to 12.3(7)JA. After the upgrade I began receiving "AP Memory Utilization is Degraded (80%)" alarms in WLSE on the upgraded APs. If I downgrade to 12.3(4)JA the problem goes away.I think the issue...

HiI've problem with transmition dhcp request from mobile clients to DHCP server.AirOnet obtain ip address from DHCP, but clients can't obtain the addresses.I configured AirOnet in agreement with instruction but steel is problem.Configuration:version ...

I have two AP-1232AG. The "a" radios configured in "bridge" mode (root-bridge and non-root-bridge). I would like to manage non-root-bridge from root-bridge LAN port. It is possible ? The non-root-bridge IP address doesnt answer me (www browser). In t...

Hello,I know this isn't Cisco specific, although I have a Cisco 1200 wireless network. While doing a security scan with NetStumbler I saw a lot of Peer to Peer (computer to computer) networks. I have a Sniffer but can not find where these computers a...

A new project require us to set up 2 AP 1200 in a room, and to configure one of the AP in standby mode. I've followed closely to the CCO documents on hot standby setup but couldn't get the standby AP to associate to the Active AP.It always give the s...

HiHas anyone configured QoS with the new AireSpace devices? I have a 4100 series controller with lots of APs, however it doesn't appear to mark QoS on the wired side of the network..I've tried enabling dot1p in the wireless config pages, however it d...

I got an AP1200 which can only load the sytem bootstrap. Details as follow:c -- Copy filef -- File dirl -- downLoad file into DRAMu -- Upload filep -- xfer Protocoln -- coNsoler -- Runs -- System info.sSystem ID: (Not shown in the forum)Motherboard: ...

Hello I have error when I import PAC file."Unable to save imported PAC data. Access denied" even if I logged as Administrator. System XP with SP2. Client ver 2.5. What kind of right I must heve ?

Is there any reason why Nokia D211 adapter fails radionetwork connectivity with Cisco AP1231G? WLAN-network is working fine when Cisco AP1231G has connectivity with Cisco PCMCIA 350 adapter(802.11b standard)Also, integrated LapTop wlan-circuit(like I...

Hi everybody!Can anyone tell me what is the best security (encryption, authentication) for a point-to-point configuration between 2 BR1310.Is it WPA2-PSK with mac adress ACL or not ?Is it possible to configure WPA2 with radius between 2 bridge? If ye...

i have a Cisco ACS appliance setup for Radius. Setup for EAP-FAST to authenticated users. Laptop has Cisco wireless card installed. the ap is already setup and being authentica with the ACS. However, no matter what i do and follow the menu from Cisco...