Wireless

I have my access-points AIR-AP1231G-E-K9 with IOS 12.3(2)JA2 configured in wpa mode.I have a notebook xp SP2 with cisco AIR-CB21AG-E-K9 card.The PEAP authentication is managed by windows and works on a cisco ACS version 3.3.The problem is that if i e...

Hi, I'm having trouble connecting my Dell Axim X50v to my new 1130 AP. I have a laptop and PC with wireless G cards connecting and accessing the network fine but am having no luck with the PDA.It can see the AP fine and tries to connect but it seems ...

Hi,I have an AP1231 I firstly configure this AP with a single SSID with wpa encryptions and also configure it to act as a local DHCP server. This all worked fine, with clients picking up and ip address etc.Now I need to configure 2 SSIDs, each with a...

I have setup a AireSpace 2006 with 3 AP's for wireless Internet Access at my site. Our SEcurity Folks want to be able to look at the GUI as a IDS. I have found that the 2006 has IDS signatures but I cannot find what I need to configure to make the de...

Even though WLSE 2.11 does not support the new IOS 12.3(7)JA, I tried upgrading an AP to 12.3(7)JA using a WLSE upgrade job and it worked just fine. I ran the same job on about 10 APs, one AP at a time, and it worked every time. What is the max numbe...

Hello,We have several 1200 AP's via dot1q connected, and Cisco PCMCIA adapters. It is possible to see some information of the AP via 'connection status'.Connection status gives e.g. the Access point Name and ip-address. I dont' want to give this kind...

Have anybody tried the Microsoft hotfix for the problem with timeouts for wireless network authentications.http://support.microsoft.com/kb/883659/

7920's tel sets seem to be roaming at bad times, user is standing right beside an AP, survey screen shows1(C),voice,56,16(A),voice,27,011(A),voice,6,0And it up and roms to the AP on chan 6 -- at which point the call quality degrads. Why would it roam...

I have a customer with some 1220 and 1230 AP's (under smartnet still) that he wants to upgrade the radio to B/G and put on a later IOS. Im ok with the radio install, but was wondering if there were any good detailed instructions on upgrading the IOS....

I have configured my aironet with vlans and want to connect to a 3550. The e0 and BVI1 will not come up on the aironet and of course the trunk will not come up3550 configvlan 10 name guest!vlan 20 name auth!vlan 30 name manageinterface Vlan1 ip addre...

Hi, I have 2 1232 AP's to set up a bridge with. Every time I enter the AP into workgroup-bridge mode, it appears to shut down the 'G' interface I want to use. It takes all the config commands but wont associate claiming no response. I've set them up ...

I have 1231-g AP's running 12.3.2(ja5) code, 3560 powered switches, and 4800 clients w/WEP enabled on them(amongst other clients running leap on a different vlan). My problem is I see the clients roaming from one ap to the next in the log and associa...

hello experts!is there a driver for AIR-CB21AG-A-K9 client card for windows 98?any help is appreciated. thanks!