Wireless

We have in our company more than 20 aironet 350. Each is connected sometimes to one host only. I would like to get the OID to get the IP address of that host or better to know the sysName of that host.

Hi All,I have a 5450 iPAQ with built in LEAP support. We use the 1100 Aironets on our WLAN. When I enable LEAP on the iPAQ the device never associates to the AP at all?I have debugged for "dot11 aaa dot1x all" on the AP but never see any events comin...

I just installed an ap350 and noticed the power injector LED flashing green instead of always lit.What does this mean ?When i disconnect the AP the led is steady orange...Please help,Lex van der LugtPQR - Holland

We have two buildings bridged with Aironet 350 and 340. The response has been very slow and there are quite a few CRC errors being produced (about 5-6 per sec) This bridges have been installed for sometime and were there when I took the job. I need...

I would appreciate the feedback for the following messages in wireless APRadio Enable Failed with error "Bad Authentication Type". Temporarily Disabling WEP Encryption and re-Attempting Enable. THIS ERROR MAY INDICATE TAMPERING WITH THE RADIO AND/OR ...

If I have a mixture of wireless Access Points, Cisco 350 and 3Com 8000, can I use a common external antenna from one or the other vendor? For example can I use Cisco antennas with 3Com Wireless Access Points?

should I be able to connect wirelessly to my Linksys BEFW11S4 Wireless Router with my Aironet 1200 setup as a repeater???I am having all kind of problems accomplishing thisThanksJR

Recently,my ap 350 showed following log information: Time Severity Description 00:10:22 (Warning): Failed to Send Packet on port "awc0" (error=0xffffffff) 00:10:22 (FATAL): Failed to stop driver for port "awc0" (error=0xffffffff)...

Hi,Does Cisco have any plan to come out with a inline power fiber media converter to support single mode fiber rather than a multimode fiber. The requirement is needed because I need to place an AP from the nearest wiring closet, but the distance is ...

I saw many message posted about VxWorks to IOS conversion. What I want to know; is cisco going to give support and new images for VxWorks or should we upgrade all VxWorks AP1200s to IOS?Okan

Hi ,Does AP 1200 support cat 6 cabling?Although the uplink is 10/100 base T.Thanks.Delon

I help operate a wireless ISP service for rural customers. Wireless rings are formed between antennes using 340s, and on each antenna are customer access APs, 340s and 350s. Currently each ring terminates at a cisco router where connection to upstrea...

Hello, I have been troubleshooting a 350 series AP for several days now. I believe the problem is that the internal transmitter is no longer functioning. I am testing with a known good wireless client and a known good antenna (Omni Ceiling Ant.). Is ...

Hi,We have the following scenario:Two 350 series APs running the latest firmware, one 7920 and several laptops using pcmcia cards.We set up everything to have the system running, VLANs, LEAP, etc. The phone successfully associates and authenticates t...

Hi,When is the 802.11g radio module available?What is the road map of the new standard?Thanks.Delon.