Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

hi!customer has configured 2 vlan's on his access point (vlan 1 = native and on other: vlan 9), each vlan has been assigned different SSID and WEP key's.laptop users can associate to both vlan's depending on which SSID and correct WEP key they use. h...

dzuodar by • Level 2
  • 497 Views
  • 1 replies
  • 0 Helpful votes

I have an AIRONET 1200 Accesspoint with 802.11 a,b,g (2 external Antennas for 802.11g) and 2 Clients. One Client with 802.11a,b,g and the other one with 802.11b. The scope with 802.11a is very bad, only one door or wall is enough to disturb the conne...

We're just beginning to test wireless and wanted to use MS-PEAP as the authentication method. Unfortunately we found that when we enabled PEAP on the adapter (Centrino on IBM laptop w/ WinXP SP1) we got the dreaded Blue Screen of Death. It blue scree...

Can an 1100 AP support trunking? Here is what I want to do.The switchport is configured for a specific vlan so everything in the wireless cloud is on that vlan currently (LEAP/WEP). I want to setup a seperate open Guest SSID vlan and put it in the sa...

sjamison by • Level 3
  • 1075 Views
  • 4 replies
  • 0 Helpful votes

Having had the IOS upgrade fail on me I cannot now get the AP to reinstall the software using the method outlined in Cisco documentation. I can access the unit using the console where I get the ap: command prompt but when I try and ping from the tftp...

petercrisp by • Community Member
  • 882 Views
  • 3 replies
  • 0 Helpful votes

Hello,When we were running AP1100's with 802.11b our ipaqs h4150/5550 with buildin 802.11b were connecting fine. Then we upgraded our AP1100's to 802.11g. Since then our h4150/5550 are connecting, but do not get an IP-address anymore. It does not hel...

Currently we have several 1200ap's deployed using LEAP with only one Cisco ACS. Most of the AP's are in one building with the ACS on the same network. A few remote offices have only 1 ap which has to authenticate back to the central ACS which then ha...

vekuhl by • Community Member
  • 565 Views
  • 1 replies
  • 0 Helpful votes

I have a 1310 configured as AP with 4 1310's configured as workgroup bridges. I also have a client using a 350series PCI card with antenna. Everything seems to work fine until the 350 client associates with the AP then everyone else behind the WGB lo...

cctnetwork by • Community Member
  • 672 Views
  • 2 replies
  • 0 Helpful votes

senerio:AP1200 VXworks 12.3T upgraded to 12.2(15)JARollout of Campus WiFi coverageMultiple SSIDs and VlansSWAN activeWLSE 2.7.1ACS 3.3OBSERVATION:A) The configuration we put on the access points contains 3 DNS servers. One ap1200 only showed one DNS ...

gwcrook by • Level 3
  • 440 Views
  • 0 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card