Wireless

Im reading here that the 2 antennas should be 1 wavelength apart (about 5 inches at 2.4ghz) pretty much just like the rubber duckies.The question is, what does that gain me? If my antennas are only 5 inches apart from each other, isnt that a minimal ...

Hello. Im having some strange issues with a 1200 AP. I believe its the environment and not actually the AP since this is the second one and it is doing the same thing.Stats on AP:Product/Model Number: AIR-AP1220-IOS-UPGRD Top Assembly Serial Number: ...

Hello all,When I install or removed 802.11 a/b/g card on the Windows 2000, the Pc crashed.Does anyone experienced this issue?I've downloaded the lastest driver install wizard v1.1 from cisco.com. I have the abg card inserted before running the instal...

Hi,Can anybody clarify what is the maximum number of wireless client associate to AP 350 at a time.

I am looking into getting AP1200 and wanted to know which external antena should I use to get the maximum outdoor wireless range? And do anybody know of a number for the wireless range? Anybody tested/experimented?thanks

If I configure an IP address on the native vlan (e.g. vlan 1, bridge group 1 -> bvi 1) I have full connectivity towards our ethernet environment. If I create a new vlan with a new linked bvi and configure again an address, I cannot access the device ...

Is it possible for a third party wireless USB 802.11 b adapter to work with Cisco LEAP? If yes, what need to be changed in Cisco 1200 access point and Cisco ACS?Any reply is welcome. Thank you.

Hello,I am trying out an AP1100, and started to work with it fresh out of the box. My first impression is that the web interface is so slow that it is unuseable ! I have done absolutely nothing to the factory config, and connected a single laptop to ...

Is there still a limitation on 30 ap's in a VLAN or Subnet in a WDS implementation?thank you..

Hello, I have problem with my wireless network. This is point-to-point network with one AIR-BR350-E-K9 (working in AP mode) and one AIR-WGB352R (as client) . The destination between two points are about 4 kilometers. I use AIR-ANT1949 (Yagi, 13.5 dBi...

why i get this message under the Location Estimation "Location could not be determined. Insufficient number of reports."

Hi, I have two AP1220's in front of me. Both AIR-AP1220B-E-K9 part numbers, identical IOS and bootloaders, (Both converted from VXR to IOS) but they differ in output power levels; first unit accepts power local 100 but the other will only accept powe...

I have a client that is using two devices on his network that have built-in wireless cards and wants to look at ACS as a security solution in his network. The devices are the Compaq IPAQ h4000 with Pocket PC 2003. The other is a Compaq Portege M200 w...

I have Local authentication turned on for the 1100 and am using the Atheros Client Utility configuring LEAP with username/password and it is failing, here is the debug from the 1100.Any help much appreciated.Xcon-ap1100#conf tEnter configuration comm...

I need to design a WLAN for 200 hosts. So, how many access points (will use 802.11b) I will need? How should I calculate this?And how should I configure them? They should be, each one, in a different channel, correct?