Wireless

I have just installed ACS and LEAP and have several Laptops in my office that have built in Wireless NIC's. I have read many posts that say this one or that one works with the right drivers, but none that list all the one's that will work with LEAP. ...

Configured a short wireless WAN link with 2 350 bridges. Link comes rioght up w/out 128bit encryption on. When encryption is enabled, link drops....any ideas. Cisco TAC didn't provide any help besides trying different data rates.

Which IOS would i need to be Mobile IP enabled ? Do i need the advanced IP feature set or the entreprise one ? would this one be enought? : 12.3 (6) IP/FW/IDS PLUS IPSEC 3DES thank you .

Hey,We recently upgraded all our 1100's to G. I now have problem with laptop's using the G nic with the novell client installed not able to log on. If I use the same laptop with a b nic everything works fine. The laptop has xp on it and I"ve bypassed...

I'm having hard time trying to understand how to configure Aironet 1200 in a way such that I have two VLANs (for example X and Y, both not 1) so that I have X for only management and management is not seen on wireless side at all, and Y for public tr...

I’m having trouble getting MAC filtering to work on my AP1231 (12.2(13)JA3). I created a new MAC filter listing my test PC card’s MAC address with the action set to “Forward” and the default action set to “Block All”. When I have the mask set to 0000...

Hello,i am trying to integrate some APs on a 2.5 WLSE (handling some thing like 1500 AP).When running the Discovery, my new APs does not appear, instead I got this message on the log:-----------------------------------------------------ThreadPool:INV...

I got 2 Cisco350 APs colocated for the same area. One is using static key WEP encryption, the other is not. The clients are both Cisco (PCMCIA & PCI) and non Cisco (IBM laptop embedded). Users asociated to the AP that uses encryption cannot start Out...

I tried to discover 3550-Switche with our Cisco WLSE V2.5. Two 3550 devices working fine (V12.2.(8)EA1)+(V12.2.(8)EA1). Other 3550 devices with V12.2.(13)EA1 didn't respond. I don't know why. (same config)-I checked the SNMP-connection with the WLSE ...

folks, Are there any known issues with using EAP authetication as well as mac address authetication???would the access-point autheticate both and only them let the client associate with itself or either.is it possible to create groups of users in ACS...

Hello,The release notes, and users guide is available. When will this be avialable for downloaded. Does anyone know?

Folks, We have a couple of G radios access-points (1200 series) in our building, I have been asked to use WLSE to secure them. I have a few questions:1) Would the WLSE detect a B radio or an A radio? if so how, because all the access-points are G rad...

Folks, Can i change the ip address of wlse from the console without running the recovery cd. Any advice would be highly appreciated.Thanks,

Dear SIr,To setup LEAP authentication using ACS, the client needs a supplicant such as the ACU to run LEAP independent of OS. Cisco AP will be the carrier of the EAP message between the client and the Radius server sitting between the client and the ...

Our Cisco 1230 access points are in a separate VLAN from our wired switches. We just purchased a WLSE, should it belong to the same VLAN as the AP's or does it really matter? Thanks.