Wireless

can lightning arrestor handle a direct lightning strike and discharge this energy to a properly installed earth ground?

what's the relation between Gain and transmitted power with coverage area?if we want add coverage area, could we just add antenna's gain only or add transmitted power only?

We have a Wireless Network and I need to know the differences between 802.11b (which we currently have) and 802.11a.Is 802.11a better than 802.11b ? Is 802.11a 128-bit Encryption ?Will current Cisco Wireless products run 802.11a or will we have to u...

Operating filters on AP 350, here is my question:What is the difference between the radio filters and the ETH filters, between RECEIVE and TRANSMIT for both ? I mean when, for instance, would I use the ETH filter rather than the radio filter for a gi...

Hello,I'm using the Aironet 340/350 Series PCI Cards with 50-mW transmit power. How can I increase the transmit power up to 100-mW? Do I need to upgrade the card? Thanks,Valery

Is the Aironet 340 able to accept power from an inline power source such as the Cisco 3524 inline power swithc?

Which vendors have you tested to be completely compatible with the Cisco AP's? I am looking specifically for a usb 1.1 client adapter or SA that will be compatible.I'm sorry if this quesiton has already been answered but I have not been able to find ...

Hi,Where can I get information on longevity/MTBF of PCMCIA wireless client adapters?

Hello,Does the Cisco AP 1200 support wireless hopping? If so, what is the maximum number of wireless hops it can support?Any information would be greatly appreciated,Thank you for your assistance,Best regards,Ros

I am trying to configure Aironet 350 on an existing WAP (Linksys WAP11) with static 128-bit WEP. Platform is Windows XP Professional. Recognizes SSID but won't associate. This WAP is currently working perfectly with other adapters.I am using Windows ...

hellowhere can i find a good technical presentation (no please not in Specs)on 802.11a thanksJYP

Is there a way control/authenticate to the AP user manager through the ACS? We have a lot of access points and I wish to control config access from a central point.Thanks!

Scenario : WLAN (AP350 V11.21) with LEAP authentication against an ACS V3.0 server (on W2K). Pre-existing Unix users with traditional Unix-crypted passwords. Usernames with their associated encrypted passwords are successfully imported on ACS databas...

I was upgradeing the firmware in an access point and it failed halfway through. Now I get the following error message. Failed to start driver for port "awc0" (errno=0x006d0002). Is there a way to fix this without sending back to the factory?

I have the 350 Cisco Wireless LAN Adapter, and I tried for the first time to upgrade it's latest firmware.In the middle of the upgrade, something happened and the upgrade process meter STOPPED and failed.Since then I cannot use the Wireless Adapter a...