Wireless

Can you connect a 350 Workgroup bridge as a client to a 350 bridge in Access Point mode? The goals is to get connectivity to 4-5 stations at a distance of .75 mile without having to use two bridges - if possible. Was thinknig of using the AIR-ANT3549...

When I install the Aironet 350 card and the client utilities on Windows 2000 or XP laptops, task list will no longer work. Hitting ctrl-alt-del brings up the normal window, but clicking task list simply returns me to windows, as if I had hit cancel. ...

Hi, How do i specify port range for global inside or outside address?amdcent

I have a 2611 router which I use for internet connection. I have 4 administratively up interfaces. Ian using NAT inside for the three inside interfaces and and NAT outside for the Internet connection interface. I have a pool of 4 legal ip addresses w...

We have AP4800E access points and using 350 WorkGroup bridges with them. We would like to activate WEP but not sure if the AP4800E supports that function. If it does, what configuration steps do you need to do at both ends(access point and bridge) to...

Does anybody have any information, regarding the following issues:1/ Do you need to have a Certificate Authority enabled on the network to use EAP-TLS (MS XP version)?2/ What is the impact of EAP on roaming? As session based keys are stored on the cl...

We have an AP350 at working running LEAP and another at another site running traditional WEP. Is there any way to have the ACU automatically pick the appropriate profile to save time?

I have one wireless bridge going to only one point, but the users are using up the bandwith. I need to get more some how. I would like to set up another point-to-point link, but I dont want to have spanning tree loops. Is there a way to get this done...

How do you turn on TKIP and MIC? I am running 11.10t firmware on the AP's.

Hi,I'm trying to understand the specific differences between the 340 & 350 bridges. We currently have (3) 340 Bridges installed which perform flawlessly. We're being told by our home office that we need to install 350s for security purposes. I'd like...

Hello,My configuration is:PCI cisco card -> AP340 <-> AP340 (repeater) <-> PCI cisco cardI read all of the manual and can not make the repeater to associate with the AP340Is there something special in the configuration ?Regards,Todor Neshev

Greetings,I would like to find out how then can we from the "AP Radio Port" page from the statistics displayed, determine if the AP is performing well. For example, how high should the PLCP CRC error or the PLCP Format error to constitute a bad perfo...

MY 2610 router had 5 serial line protocols down. My telcomms company has verified that all the lines are ok. One of the interfaces now is up. I dont know how I can debug the router to check what the problem may be. If I use the clear interface comman...

I am interested in either the Aironet 340 or 350. The only difference I can seem to find is the 350 is a higher powered AP. Is this the only major difference?I am interested in a SOHO setup and my office is in a converted garage. I need to share the ...

Has anybody managed the Aironet 350 APs using CiscoWorks 2000? If so, what can you tell me. I have doubts about if you can do more things using CW2000 than if you are using HP OV. Of course if you want to manage CISCO switches the CW2000 gives you mu...