Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Welcome to the Cisco Community Ask Me Anything Event   Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...

Shree Hari AB.jpeg Screenshot 2026-09-11 at 3.12.04 PM.png

Hello Sir, I want know the details regarding planning and implementing wireless solution and technologies in power plant controls. (I will install a WLAN in a power plant). I want know all the different wireless technologies with all the details. Any...

hi all,is there is any one who knows about the security issue if u have the cisco 350 AP andother vendors PC cards, i mean to say what kind of security that we can achive from this mix setup.will this setup provide the EAP, MIC, KEY ROTATION or DYNAM...

sameer by • Community Member
  • 751 Views
  • 0 replies
  • 0 Helpful votes

I am currently connecting a remote office to the main building using 340 bridges. Can I add another Antenna/bridge to "double" the link speed or will it simply provide a redundant connection?

p-cayen by • Community Member
  • 1121 Views
  • 4 replies
  • 0 Helpful votes

I have a BSE342 currently loaded with 8.51 firmware, and I only see an *explicit* upgrade to 8.52 on the software page. But it seems as if Access Point firmware is compatible and that the terms are actually interchangeable at this point ("Base Statio...

dbrazil by • Community Member
  • 731 Views
  • 1 replies
  • 0 Helpful votes

Does WEP work on uc4800 single clients. I see it can be implemented on the Access Poinst, but don't see how to enable it on the Singles. If WEP is not possible, then are there any encryption alternatives.

gmcgee by • Community Member
  • 904 Views
  • 1 replies
  • 0 Helpful votes

I have an Aironet 350 access point and also a workgroup bridge. I can ping & communicate with the workgroup bridge's ip address for setup & diagnostics from the bridge's ethernet side, but I cannot see it from the wireless side, i.e., through the AP!...

rmuzzi by • Community Member
  • 874 Views
  • 1 replies
  • 0 Helpful votes

Dear Sir, My question is related with the wireless network IEEE 802.11b especially its physical layer. Is there a software (or an extender PC Card) to use with the PCMCIA Card IEEE 802.11b in a Laptop in order to extract some measurements concerning ...

Jemai by • Community Member
  • 949 Views
  • 2 replies
  • 0 Helpful votes

I noticed in the log of one of our access points the there are several Radio Error : Holdoff timeouts and also several Queue full discards. Why are we getting these and what can be causing them. Thanks.

rx33328 by • Community Member
  • 708 Views
  • 1 replies
  • 0 Helpful votes

We have installed test Aironet 350 AP's and cards to try to get a reasonable level of security for wireless (LEAP, MIC, WEP key rotation, etc.). We have LEAP enabled and working, and have the AP's configured to require network EAP. The one troubling ...

jfarmer by • Community Member
  • 822 Views
  • 1 replies
  • 0 Helpful votes

I have been able to get Xircom wireless adapters to use the draft 8 standard when using LEAP authentication. However, they cannot use draft 10 due to the outdated firmware available for them. I wonder if it might be possible to flash them with airone...

markyrules by • Community Member
  • 919 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card