Wireless

I am trying to put a plan in place for our sales staff (who are on the road alot), I would like to get in with a large wireless provider to help in this endeavor. I cannot find a good single source provider. Does anyone know of one.

We have buyed 2 wireless bridge AIR-BR350-E-K9 but in configuration is impossible to set this 2 units as bridge, there are only 3 field: As AP, as repeater and the last as client.Someone have had this kind of problem?

I have a couple of AP340's set up to do LEAP authentication via RADIUS on ACS. All of my clients, until today, were Cisco NICs. I have a need to enable and configure MAC authentication for a Lucent NIC. Has anyone had any success enabling both LEAP a...

What is the official word from Cisco regarding the introduction of both 5 gig access points and bridges?

Hi!We are in a process of building out an Aironet350 WLAN and after the network grew over 100 APs the Client Associations list went out sync on various APs, type of Client Adapter shown incorrectly, client names were missing, etc. When the network wa...

The following question/answer was taken from a past Wireless Tech Talk. Does anyone know if this includes the 4800 AP when upgrading from 11b to 11g? Or is this for 340's/350's only!What is required to upgrade AP's from .11b to 11g., then from .11g t...

I have two Lucent (Orinoco) access points, the AP-500 and the AP-1000. I have the 128-bit WEP encryption enabled and currently the use the Orinoco Gold cards to access the network. Everything works fine. Now I have a need to use a wireless Cisco card...

Does anyone have a used Pix FW or VPN concentrator for sale?

In Windows 2000, my Cisco Aironet 350 series cards ACU window had a checkbox in the "System Parameters" tab of the "350 Series Properties" window. The checkbox appeared under the "Default Profile" section. It said "Enable Auto Configuration Switching...

I have two routers and between a PIX. Fact is that multicast traffic on a PIX isn'tallowed and I will not create a GRE tunnel.I configured on the two routers OSPF with theneighbor commands and permit OSPF on the PIX,but it doesn't work, so has anybod...

I'm looking to get into wireless networking. Starting next semster I will pick up some general books about wireless but I wanted to read up on some Cisco too. I've been searching all over for a Cisco Wireless Certification and Cisco books on wireless...

Hi,I have two ISA based 340 series aironet cards. Recently, I have started to upgrade to more modern systems, but I cannot use the aironet cards because all of my new motherboards require PCI cards. Is it possible to purchase new PCI carriers? I woul...

My 350 pcimcia card does not recognize my 4800 access point..my 340 card works fine.

I currently use a Cisco AIR-LMC342 PCMCIA and the Cisco "Rabbit ears" antenna to connect to the 802.11b Internet provider in my area. I want to up grade to a better antenna mounted outside the passenger compartment.Questions:1. What mobile antenna pr...

We are having problems with our RF scanners that use 340 DOS drivers. They get disconnected from the HOST 3 or 4 times a day. We have 350 AP's for our wirless backbone. We also have laptops (running win2k)using 340 and 350 client cards and we never s...