Wireless

I have a AP350 in my home connect to a switch that is connected to a cable modem. All PC's that I connect to the switch get a different IP address thru DHCP. My problem is that I can not get more than one device to Associate with the AP. I have two 3...

RF scanner i use is comply to ieee 802.11b. It has been working fine with AP4800 and 340 Series. BUt when i tried with 350 series, it just didn't work out.I understand that i just need to put in the SSID and no other configuration requires.But it sti...

I have just set up 3 Aironet 350 APs, all signals overlap and all APs have the same SSID.All APs are also set up on differant channels (1,6,and 11). I'm also using LEAP. I'm using Compaq iPAQs with the Cisco Aironet 350 PCMCIA cards as the clients. E...

Anybody know what chipset the Cisco card uses? Can't find it in the specs.

Are there specific distances that antennas should be placed to maximize the benefit of antenna diversity in an 802.11b compliant WLAN?

I am setting up wireless network for a customer using 1 Cisco Aironet 340 bridge and 2 340 Workgroup bridges. The main bridge is going to have to reside outdoors, so I will need a NEMA enclosure. Does anybody have a recommended enclosure to use? Can'...

Hello, all:I have a pair of wireless CISCO Aironet 340 LAN adapter (client) and wireless CISCO Aironet 340 AP. Each was running perfectly fine just few days ago along with other wireless products. However, when I decided to go through an upgrade with...

Hello,I am currently looking for some products to help me setup a a wireless LAN and I was wondering if your company might be able to offer some advice as well as equipment suggestions.The goal of the network will be to allow people within at least a...

I am trying to secure a bridged network. I've setup LEAP before for AP to client communication before, but I can't find anything about Bridge to Bridge LEAP.Is this possible?Thanks

Hi - OK I've had a site up and running for about 1 month, there are 4 buildings over the span of about 2 miles. One of the buildings has 2 bridges in it because of the distance required for the last hop (about 1.25 miles). So one of those 2 bridges k...

I have Aironet 340 Ap, which should be able to communicate with nokia c110 wlan card. I can see the Cisco Ap from Nokia's client application, but Cisco Ap won't associate Nokia client. Is there some setting in aironet that should be turned on/off. I ...

We have been asked by the British Government to supply a WLAN solution. Obviously this needs to be as secure as possible, so LEAP and RADIUS along with ACL's and Dynamic WEP are not enough to protect the data itself as its transmitted over the air. T...

I am using Linksys Etherfast wireless ap + cable/dsl router (model BEFW11S4). I want to use cisco 340 to repeat wireless signal. My Cisco NIC changes from Linksys to Cisco wireless signal but it looses IP configuration. Linksys is my DHCP server as w...

Does anyone have recommendations for positioning Access Points (we have 340's) for best throughput and simultaneously best area coverage for our laptops in a one-story building. I'm getting only about 2.8-3.3 Mbits/sec real TCP throughput (with 128 b...

[email protected] Sir , I am Planning to setup of a Network through wireless, But I am Confuse which product I will use .. CISCO Aironet 350 Series .. but I have to give a setup in 5 place in that case one station is in Middle & rest of the ...