Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,My company is exploring wireless dial-up i.e. wireless version of modem dial-up. Pls advise if there's any commercial product to filfill the objective.Tks.Regards
I just deployed a WLAN for a customer whose using preexisting Apple Airport cards (which I believe are rebadged Lucent Silver cards). I set the 350 Series APs to emulate a plain-vanilla 802.11b AP.The Apple ibook can see network servers & printers (v...
I have an cisco 3640 and i install the NM-1E2W,but when i install the wic-2t doesn't reconized the router doesn't reconized serial ports just ethernet port,this is the message that i recieved,when it boots %QUICC-1-UNKNOWN_WIC: Quicc(3), wic card has...
I have two PBXs in two buildings about 100 yards from each other with a good line of sight. How can I link the two phone systems using a radio solution. Ther are only 16 users at the smaller of the two buildings.What is the best technology?
I have a customer looking to deploy a WLAN. His users are distributed over 3 VLANs. He would like to have his users be able to roam throughout the WLAN, and still retain their VLAN assignments.We thought we could do this via dynamic VLAN ports, but s...
We have a Cisco 342 wireless nics installed on some new systems. Each system has a modem hooked up to it. Windows 2000 pro is loaded. When the modems begin to dial, the system locks up. If I take out the wireless nics, the modem and system work fine ...
I have used a GSM wireless connection for the last two years to access our local traffic camera system from my commercial vehicle. The information from the trafficams has proven to be very useful for enroute planning. At 9.6 K download speed it has b...
I am looking for an on-line/electronic version of the mounting instructions for the AIR-ANT3195 Patch Wall Mount Antenna. I have searched CCO and can't seem to locate it. If someone knows the location, please reply.Thank you,Jeff.
I am trying to configure two bridges to link two network together. I can ping One brdge from the other but cannot ping a system from one network to another.Can the brdge be configured as a gateway?What is the problem.
I was wondering if someone knows a company or even Cisco itself sells amplifier or amplifier connectors to the RP-TNC connector of the Aironet AP.Thanks in advance!
